Question is ⇒ The V<sub>TH</sub> at terminals A and B is equa, Options are ⇒ (A) 0 V, (B) 5 V, (C) -5 V, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ The V<sub>TH</sub> at terminals A and B is equa, Options are ⇒ (A) 0 V, (B) 5 V, (C) -5 V, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The V_TH at terminals A and B is equa
A.	0 V [Wrong Answer]
B.	5 V [Correct Answer]
C.	-5 V [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following can be operated with positive as well as negative gate voltage?
JFET
Both JFET and MOSFET
MOSFET
Neither JFET nor MOSFET

⇒ A good dielectric should have
low losses
good heat conductivity
high intrinsic strength
all of the above

⇒ In the above case the hexadecimal notation for the last memory location is
0
FFFF
3FFF
5FFF

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ Consider the following stateme
1, 4 are correct
1 and 2 correct
1, 2, 3 are correct
2, 3, 4 are correct

⇒

Match the following:

	List I		List II
A.	R = 0	1.	Undamped oscillation
B.	R < 2 L/C	2.	Damped oscillation
C.	R = 2 L/C	3.	Critically damped response
D.	R > 2 L/C	4.	Non-oscillatory response.

A-1, B-2, C-3, D-4
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-3, B-4, C-1, D-2

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact

⇒ In a photo transistor the photocurrent is
emitter base junction
collector base junction
collector
either (a) or (b)

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ A voltage DAC is generally slower than current DAC
because of more accuracy
because of higher resolution
because of response time of op-amp current to voltage converter
none of the above

⇒ In 8085 microprocessor, how many interrupt control lines are there?
6
8
12
16

⇒ The most commonly used system of modulating for telegraphy is
single tone modulation
on-off keying
frequency shift keying
pulse code modulation

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Equipotential surfaces about a point charge are in which one of the following forms?
Sphere
Planes
Cylinders
Cubes

⇒ ALU processes
decimal numbers
binary numbers
hexadecimal numbers
all of the above

⇒ Maximum power transfer theorem finds application in
power circuits
distribution circuits
communication circuits
both power and communication circuits

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ Many compounds also exhibit semiconducting properties.
TRUE
FALSE

⇒ The unit of displacement density is
volt/metre
ampere/metre²
coulombs/metre
coulombs/metre²

⇒ A dependent source
may be a current source or voltage source
is neither a current source nor a voltage source
is always a voltage source
is always a current source

⇒ In magnetic film memory, the memory element consits of
plated wires
superconductive material
nickel iron alloy
doped aluminium

⇒ In 8086 the number of lines on which data and address is multiplexed is
8
16
20
32

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ For a junction FET in the pinch off region as the drain voltage is increased, the drain current
becomes zero
abruptly decreases
abruptly increases
remains constant

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1