Question is ⇒ The method of frequency compensation in moving iron voltmeter is, Options are ⇒ (A) to use a capacitor in series with coil, (B) to connect a capacitor in parallel with coil, (C) to connect a capacitor in parallel with series resistance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The method of frequency compensation in moving iron voltmeter is, Options are ⇒ (A) to use a capacitor in series with coil, (B) to connect a capacitor in parallel with coil, (C) to connect a capacitor in parallel with series resistance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The method of frequency compensation in moving iron voltmeter is
A.	to use a capacitor in series with coil [Wrong Answer]
B.	to connect a capacitor in parallel with coil [Wrong Answer]
C.	to connect a capacitor in parallel with series resistance [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒

Assertion (A): There are no convergence issues with the discrete-time Fourier series in general.

Reason (R): A discrete-time signal is always obtained by sampling a continuous-time signal.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ Hysteresis curve is associated with motion of domain walls.
TRUE
FALSE

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ An op-amp has zero gain for common mode inputs. Then CMRR =
zero
infinite
high
low

⇒ In Schottky TTL, a Schottky diode is used for
forming the gate
connecting the resistor
clamping of the basic collector junction
none of the above

⇒ A modem is
a form of commutator
a device for digitizing speech
a circuit used for suppressing microwave mterference
an electronic circuit which carries out modulation and demodulation of a carrier frequency

⇒

Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give
A + (B + C) D
A + BC + D
A(BC + D)
none of these

⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ In broadside array
the principle direction radiation is perpendicular to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and perpendicular to the plane containing the array elements
the principle direction radiation is perpendicular to the array axis and parallel to the plane containing the array elements

⇒ Inverse Fourier transform of '1' is
U(t)
δ(t)
0'
infinite

⇒ Which bridge can be used to measure frequency?
Maxwell
Kelvin
Schering
Wein

⇒ The distributors for residential areas are
single phase
three phase three wire
three phase 4 wire
(a) or (b)

⇒ Which of the following modulation is analog in nature?
PCM
DPCM
DM
PDM

⇒ With four Boolean variables, how many Boolean expressions can be performed?
16
256
1024 (1 K)
64K (64 x 1024)

⇒ Which of the following has a major role in implementation of functions calls in C?
Processor's registers
Data segment
The heap
System stack

⇒ Which of the following is invalid in Basic?
A ** B + - C
A ** B - C
A * B - C
A * B - C ** D

⇒ The number of repeaters in a coaxial cable link depends on
system bandwidth
separation of equalizers
the number of coaxial cables in the tube
none of the above

⇒ An ideal op-amp can amplify dc signals
TRUE
FALSE

⇒ In an ac circuit, the maximum and minimum values of power factor can be
2 and 0
1 and 0
0 and -1
1 and -1

⇒ In figure what is value of I_C if β_dc = 100. Neglect V_{BE5 mA
5 μA
10 mA
10 μA}

⇒ In a bridge inverter with single pulse width modulation
the output frequency is equal to frequency of reference signal
the output frequency is equal to frequency of control signal
either (a) or (b)
neither (a) nor (b)

⇒ In VCR the luminance signal is recorded by
frequency modulation
phase modulation
amplitude modulation
direct recording

⇒ The skip distance is
same for each layer
independent of frequency
independent of the state of ionisation
independent of transmitted power

⇒ As regards single phase dual converter
the change in operation from one quadrant to the other is faster in non-circulating current mode
the change in operation from one quadrant to the other is faster in circulating current mode
the time response to change in operation from one quadrant to other is the same in both the modes
the time response to change in operation from one quadrant to the other may be faster in any of the two modes

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE