Question is ⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause, Options are ⇒ (A) unwanted low frequency oscillations, (B) unwanted high frequency oscillations, (C) unwanted oscillations at low and high frequencies, (D) large feedback, (E) , Leave your comments or Download question paper.

Question is ⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause, Options are ⇒ (A) unwanted low frequency oscillations, (B) unwanted high frequency oscillations, (C) unwanted oscillations at low and high frequencies, (D) large feedback, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The stray capacitance between the last stage and the first stage of an oscillator may cause
A.	unwanted low frequency oscillations [Wrong Answer]
B.	unwanted high frequency oscillations [Correct Answer]
C.	unwanted oscillations at low and high frequencies [Wrong Answer]
D.	large feedback [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The conductivity of germanium increases by about 6 percent per degree increase in temperature.
TRUE
FALSE

⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A
both the average and rms thyristor currents will be less than 20 A
both the average and rms thyristor currents will be more than 20 A
rms thyristor current will be 20 A and average thyristor current will be 10 A

⇒ The type of feedback in the following circuit diag
Voltage shunt
Current-shunt
Voltage series
Current series

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In 8085 microprocessor, what is the length of PC (program counter)?
6 bits
8 bit
12 bits
16 bits

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bit) is FFFF. Its magnitude in decimal representation is
0
1
32676
65, 535

⇒ A decoder can be used as a demultiplexer.
TRUE
FALSE

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1

⇒ An RC snubber circuit is used to protect a thyristor against :
false triggering
failure to turn on
switching transients
failure to commutate

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ Which of the following identifiers is invalid in Pascal?
BETA
MAX 40
2ND
A MAX

⇒ Which of the following cannot provide as much time interval accuracy as the oscilloscope but can capture and display eight or more signals simultaneously, something that scopes cannot do?
Logic analyzer
Digital oscilloscope
Frequency analyzer
Wave analyzer

⇒ In a rectifier circuit the filter capacitance is increased. Then the ripple will
increase
decrease
remain the same
either (a) or (b)

⇒ In the below figure, the load is highly inductive. The firing angle is a for each of the thyristors. The periods of conduction of Th₁ and Th₂ respectively
0 to p and p to 2p
a to p and p + a to 2p
a to p + a and p + p to 2p + a
a to p - a and p + a to 2p - a

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ Consider the following statements about radar Beacon

It is also called transponder.
It includes pulse transmitter, receiver and antenna.
It replies with full power even when the signal receives is weak.

Which of the above statements are correct?
All
1 and 2 only
2 and 3 only
2 only

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ In which n type device does p substrate extend upto silicon dioxide layer?
JFET
Depletion type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ Armstrong F.M. transmitter performs frequency multiplication in stages
to increase the overall S/N
for convenience
to reduce the bandwidth
to find the desired value of carrier frequency with frequency deviation

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ A capacitor can be represented by a capacitance C in parallel with a resistance R. For a good capacitor, the resistance R should be
very high
high
very low
low

⇒ A TV. transmitting aerial is fixed on top of a 150 metre tower located on a mountain 1200 m height. The range of transmitter is
51 km
152 km
152 m
51 m