Question is ⇒ A fascimile reproduction has a specification of 200 lines per frame, progressive scanning and 5 frames per second. The time to scan one line is, Options are ⇒ (A) 5 ms, (B) 2.5 ms, (C) 1 ms, (D) 0.1 ms, (E) , Leave your comments or Download question paper.

Question is ⇒ A fascimile reproduction has a specification of 200 lines per frame, progressive scanning and 5 frames per second. The time to scan one line is, Options are ⇒ (A) 5 ms, (B) 2.5 ms, (C) 1 ms, (D) 0.1 ms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A fascimile reproduction has a specification of 200 lines per frame, progressive scanning and 5 frames per second. The time to scan one line is
A.	5 ms [Wrong Answer]
B.	2.5 ms [Wrong Answer]
C.	1 ms [Correct Answer]
D.	0.1 ms [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A decade counter skips
binary states 1000 to 1111
binary states 0000 to 0011
binary states 1010 to 1111
binary states 1111 to higher

⇒ In a tape recorder
the width of air gaps of record and erase heads is almost equal
the air gap of record head is wider than the air gap of erase head
the air gap of erase head is wider than the air gap of record head
any of the two air gaps can be wider than the other

⇒ δ(t) is a
energy signal
power signal
neither energy nor power
none

⇒ For any given two port network, any parameter set can be determined from measurements made at the two ports.
TRUE
FALSE

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒

Match the following:

	List I		List II
A.	Ternary	1.	0, 1, 3
B.	Quaternary	2.	0, 1, 2, 3, 4, 5, 6 7, 8, 9, A, B
C.	Quinary	3.	0, 1, 2, 3, 4
D.	Duodecimal	4.	0, 1, 2

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-1, C-4, D-3
A-4, B-1, C-3, D-2

⇒ The precision of an instrument indicates its ability to reproduce a certain reading with a given
drift
resolutions
shift
consistency

⇒ F.T. of continuous non-periodic signal is
aperiodic
periodic
a and b
none

⇒ As comparated to an ordinary p-n diode, the extent of impurity atoms in a tunnel diode
is more
is less
may be more or less
is almost the same

⇒ Distilled water at 25°C is characterized by σ = 1.7 x 10^-4 mho/m and ε = 78 ε₀ at a frequency of 3 GHz. Its loss tangent is (ε = 10^-9/36p F/m)
1.3 x 10^-5
1.3 x 10^-3
1.7 x 10^-4/78
1.7 x l0^-4/78ε₀

⇒ Almost all resistors are made in a monolithic integrated circuit
during the entire diffusion
while growing the epitaxial layer
during the base diffusion
during the collector diffusion

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ Antenna commonly used for microwave links are
loop antennas
log periodic antennas
paraboloidal dishes
rhombic antennas

⇒ Poor power factor
reduces load handling capability of electrical system
results in more power losses in the electrical system
overloads alternators, transformers and distribution lines
all

⇒ Which of the following should dominant wave have?
Lowest cut off frequency
Highest cut off frequency
No attenuation
No phase shift

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒

Assertion (A): A semiconductor strain gauge is more accurate than a resistance strain gauge.

Reason (R): The gauge factor of a semiconductor strain gauge is about 100 where as the gauge factor of a resistance strain gauge is only about 2.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the circuit of figure. The current supplied by battery at t = &infin
0
0.208333333333333
less than 5 A
very large

⇒ Industrial noise has the frequency range of
1 to 100 Hz
200 to 5000 Hz
above 200 MHz
1 to 600 MHz

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ Each cell of static RAM contains
4 MOS transistors
4 MOS transistors and 1 capacitor
2 MOS transistors
4 MOS transistors and 2 capacitors

⇒ The initial state of MOD-16 down counter is 0110. What state will it be after 37 clock pulses?
Indeterminate
110
101
1

⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ In the given figure the time taken by the wave to make one round tri
10 ns
20 ns
30 ns
40 ns