Question is ⇒ In case of a transistor amplifier the emitter resistance R<sub>e</sub> is removed, Options are ⇒ (A) the gain of the amplifier will reduce, (B) heat sink will not be required, (C) Q-point will become unstable, (D) base to emitter function will be less forward biased, (E) , Leave your comments or Download question paper.

Question is ⇒ In case of a transistor amplifier the emitter resistance R<sub>e</sub> is removed, Options are ⇒ (A) the gain of the amplifier will reduce, (B) heat sink will not be required, (C) Q-point will become unstable, (D) base to emitter function will be less forward biased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In case of a transistor amplifier the emitter resistance R_e is removed
A.	the gain of the amplifier will reduce [Wrong Answer]
B.	heat sink will not be required [Wrong Answer]
C.	Q-point will become unstable [Correct Answer]
D.	base to emitter function will be less forward biased [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A network is causal if impulse response is zero for t < 0.
TRUE
FALSE

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒

Assertion (A): In an op-amp the gain bandwidth product equals f_finity

Reason (R): The change in open loop gain of an amplifier has almost no effect on closed loop gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): SUS is a PUT and avalanche diode connected between gate and cathode

Reason (R): SBS has two SUS inbuilt together and connected in anti-parallel

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A line has standing waves with a voltage maximum of 35 mV and minimum of 17.5 mV VSWR is
2
4
0.5
0.25

⇒ A cascade amplifier stage is equivalent to
common emitter stage followed by a common base stage
common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒ In a Parallel connection of circuit the bandwidth in terms of R, L, C is
B = 1/RC
B = 1/RL
B = 1/RLC
B = RLC

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ Suppose a microprocessor has memory locations from 0000 to 3FFF, each storing I byte. How many bytes the memory can storing I bytes the memory can store?
4384
8644
12688
16384

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same

⇒ In a satellite system circular polarization is to be obtained. The antenna used is
parabolic
horn
log periodic
helical

⇒ The minimal function that can detect a "divisible by 3" 8421 BCD code digit (representation D₈D₄D₂D₁) is given by
D₈D₁ + D₄D₂ + D₈D₂D₁
D₈D₁ + D₄D₂ D₁ + D₄D₂D₁ + D₈D₄D₂D₁
D₄D₁ + D₄D₂ + D₈D₄ D₂D₁
D₄D₂D₁ + D₄D₂D₁ + D₈D₄D₂D₁

⇒ Magnetic deflection sensitivity is defined as
deflection/flux density
(deflection/flux density)^0.5
(Deflection)^0.5/flux density
none of the above

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ With respect to the Miller integrator sweep shown below, the sweep rate wil
2
4
1.5
2.5

⇒ The number of operator to accomplish basic arithmetic in Java is
4
5
6
7

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒ Antenna commonly used for microwave links are
loop antennas
log periodic antennas
paraboloidal dishes
rhombic antennas

⇒ A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is
1 kΩ
200 kΩ
100 kΩ
50 kΩ

⇒ The diagram to show distance time history of electrons in klystron amplifier is called
apple gate diagram
asynchronous diagram
bunching diagram
velocity modulation diagram

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ The work done in moving a charge Q on an equipotential line for a distance d will be
V/d
QV/d
Q.d
zero

⇒ Vestigial sideband is most commonly used in
radio transmission
television transmission
telephony
all of the above

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ In the television system in India, each channel is allowed a bandwidth of
20 MHz
12 MHz
7 MHz
3 MHz

⇒ The effective refraction index of the ionosphere for radio wave is
more than unity
less than unity
equal to unity
either more or less than unity depending on the electron concentration

⇒ Ridge waveguide is essentially a form of capacitively loaded guide.
TRUE
FALSE