Question is ⇒ figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output, Options are ⇒ (A) 0, (B) 1, (C) AB, (D) AB, (E) , Leave your comments or Download question paper.

Question is ⇒ figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output, Options are ⇒ (A) 0, (B) 1, (C) AB, (D) AB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
A.	0 [Correct Answer]
B.	1 [Wrong Answer]
C.	AB [Wrong Answer]
D.	AB [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ In the figure shows the circuits symbo
FET
PMOSFET
CMOSFET
NMOSFET

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
11
-11
10
-10

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ An homogeneous dielectric material is subjected to an electric field E. If a small cavity is made inside the material, the electric field intensity inside and outside the cavity are different.
TRUE
FALSE

⇒ Elements R, L, C are connected in parallel and excited by a dc current I. If i_R, i_L and i_C are the currents through R, L, C respectively then at t = 0
i_R > i_L > i_C
i_L > i_R > i_C
i_C = 0
i_C = I

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒ If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is
r = 0.5, S is required
r = 1.0, S is required
r = 0.5, S is not required
r = 1.0, S is not required

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ A semiconductor Read-only-Memory basically is
a combinational logic circuit
a set of flip-flop memory elements
a sequential circuit with flip-flops and gates
none of the above

⇒ If 4 in binary system is 100 then 8 will be
10
100
111
1000

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact

⇒

Assertion (A): Impatt diode can be used in both amplifiers and oscillators.

Reason (R): Impatt diode has a low resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The pure capacitor connected across an A.C. voltage consumed 20 W. This is due to
the capacitive reactance in ohms
the current flowing in the capacitor
the fused capacitor was a big one
none of the above

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ In a three input AND gate A = 1, B = 1, C = 0 The output Y =
ABC
ABC
ABC
ABC

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are
100 Hz each
50 Hz each
100 Hz and 50 Hz
50 Hz and 100 Hz

⇒ In a four element Yagi-Uda antenna
there is one driven element, one director and two reflectors
there is one driven element, two directors and one reflector
there are two driven elements, one director and two reflectors
all the 4 elements are driven element

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6