Question is ⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω), Options are ⇒ (A) F(jω), (B) F*(j↔), (C) F*(- jω), (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω), Options are ⇒ (A) F(jω), (B) F*(j↔), (C) F*(- jω), (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If f(t)↔ F(jω), and f(t) is real, then F(- jω)
A.	F(jω) [Wrong Answer]
B.	F*(j↔) [Correct Answer]
C.	F*(- jω) [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Magnetic deflection sensitivity is defined as
deflection/flux density
(deflection/flux density)^0.5
(Deflection)^0.5/flux density
none of the above

⇒ Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
variable
low
negative
positive

⇒ How many interrupts are there of 8085 μP?
4
5
6
8

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒ In a metal, the drift velocity of electrons in the presence of a electric field E is
proportional to E
proportional to E
inversely proportional to E
proportional to E²

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ In a photodiode the current is due to
majority carriers
minority carriers
both majority and minority carriers
either (a) or (b)

⇒ The Fourier transform of f(t) = cos ω₀t is
p[δω₀ + δ(- ω₀)]
p[δ(ω - ω₀) + δ(ω + ω₀)]
p[δω₀ - δ(- ω₀)]
p[δ(ω - ω₀) - δ(ω + ω₀)]

⇒ A reflex klystron oscillator is a
low power device
high power device
high efficiency device
both (a) and (b)

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ Dielectric constant and conductivity of rocky soil and flat sandy soil are around
10 and 20 mho/cm respectively
20 and 10 mho/cm respectively
2 and 5 mho/cm respectively
0.5 and 2 mho/cm respectively

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ Troposphere is the upper part of the Earth's atmosphere which absorbs large quantities of Sun's radiations.
TRUE
FALSE

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in
a change in o.c voltage
a change in s.c current
decrease in resistance
increase in resistance

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ A magnetic field exists around
moving charges
static charges
iron
copper

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ A JFET operates in ohmic region when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = is Positive
V_GS = V_DS

⇒ In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 1
5(1 - e^-0.05n)
5e^-0.05n
5(1 - e^-5n)
5^e-5n

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the given figure the number of combinations of three non touching loop
0
1
2
3

⇒ Which of the following power amplifiers has highest efficiency?
Class A
Class AB
Class B
Class C

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒ Consider the following as regards cumulative disribution function F(x)

0 ≤ F(x) ≤ 1
F(- ∞) = 0
F(∞) = 1
F(x₁) ≤ F(x₂) If x₁ < x₂

Out of above which are correct?
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4

⇒ The residual resistivity of a binary alloy at 0°K is
the sum of the residual resistivities of the component metals
the difference of the residual resistivities of the component metals
the product of the residual resistivities of the component metals
depend on the concentration of the minor component in the alloy