Question is ⇒ Magnetic recording tape is most commonly made from, Options are ⇒ (A) small particles of iron, (B) silicon iron, (C) ferric-oxide, (D) silver nitrate, (E) , Leave your comments or Download question paper.

Question is ⇒ Magnetic recording tape is most commonly made from, Options are ⇒ (A) small particles of iron, (B) silicon iron, (C) ferric-oxide, (D) silver nitrate, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Magnetic recording tape is most commonly made from
A.	small particles of iron [Wrong Answer]
B.	silicon iron [Wrong Answer]
C.	ferric-oxide [Correct Answer]
D.	silver nitrate [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minimum step size required for a Delta modulator operating at 36 samples/sec to track the signal (here u(t) is the unit step function) x(t) = 125t (u(t) - u(t - 1)) + (250 - 125t) (u(t - 1) - u(t - 2)) So that slope overload is avoided, would be
2^-10
2^-8
2^-6
2^-4

⇒ For a system to be designated as hi-fi, the signal to noise ratio should be at least
25 dB
50 dB
75 dB
100 dB

⇒

Assertion (A): Slotted line is frequently used for microwave measurements.

Reason (R): The unknown impedance is mounted at the end of slotted line.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The complement of Boolean expression AB (B C + AC) is
(A + B) + (B + C) + (A + C)
A B + (B + C)(A + C)
(A + B) + (B + C) (A + C)
none of the above

⇒ As per BIS there are 6 accuracy classes of instruments.
TRUE
FALSE

⇒

Assertion (A): CRO can be used to study waveshape accurately.

Reason (R): Input impedance of a CRO is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above

⇒ The voltage applied to an R-L circuit at t = 0 when switch is closed is 100 cos (100 t + 30°). The circuit resistance is 80 Ω and inductance is 0.6 H (in which initial current is zero). What is the maximum amplitude of current flowing through the circuit?
0.0416666666666667
0.0833333333333333
0.208333333333333
0.416666666666667

⇒ For the K map of the given figure, the simplified Boolean expressio
A C + A D + ABC
A B D + BC
A C D + AC
A C D + AC + BC

⇒ A transistor is said to be in a quiescent state when
the amplitude of input and output signal is equal
the phase of input and output signal is identical
no signal is applied to the input
the transistor is unbiased

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ Equipment using BCD numbers
pocket calculators
electronic counter
digital voltmeters
all of the above

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒

Assertion (A): In design of circuit using BJT, a derating factor is used.

Reason (R): As the ambient temperature increases, heat dissipation becomes slower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is not an assembler directive in 8085?
D S
D B
D Q
E Q U

⇒ Assuming that k is an integer what would the result of following expression
8
7
7.5
zero

⇒ Ebers Moll model is applicable to
bipolar Junction transistor
N MOS transistor
unipolar junction transistor
field effect transistor

⇒ Consider a multiplexer with X and Y as data inputs and Z as control input. Z = 0 selects input X and Z = 1 selects input Y. What are the connections required to realize the 2-variable Boolean function f = T + R, without using any additional hardware?
R to X, 1 to Y, T to Z
T to X, R to Y, T to Z
T to X, R to Y, 0 to Z
R to X, 0 to Y, T to Z

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
31 v
32 v
insufficient data
none of these

⇒ Which of the following is not a characteristic of a flip flop?
It is a bistable device
It has two outputs
It has two outputs are complement of each other
It has one input terminal

⇒ In the switching circuit, switches A, B have value 0 for OFF, 1 for ON and the output Y has 0 volts for 1 volts, then the expression for
AB
A + B
A + B
AB

⇒ In an ac circuit the fundamental component of current wave lags the corresponding voltage wave by 20°. The third harmonic component of current wave lags the corresponding voltage by an angle.
less than 20°
more than 20°
equal to 20°
equal to or more than 20°

⇒ Digital circuits mostly use
Diodes
Bipolar transistors
Diodes and bipolar transistors
Bipolar transistors and FETs

⇒ As compared to a bipolar transistor, a JFET is
highly sensitive to changes in input voltage
more sensitive to changes in input voltage
less sensitive to changes in input voltage
equally sensitive to changes in input voltage