Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): A JFET behaves as a resistor when V_{GS} < V_{P}. Reason (R): When V_{GS} < V_{P}, the drain current in a JFET is almost constant. | |
A. | Both A and R are true and R is correct explanation of A [Wrong Answer] |
B. | Both A and R are true but R is not a correct explanation of A [Wrong Answer] |
C. | A is true but R is false [Correct Answer] |
D. | A is false but R is true [Wrong Answer] |
View Answer
Explanation:-
Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)
⇒ The inverse Fourier transform of δ(t) is
∪(t)
1
δ(t)
e^{j2pt}
⇒ A dc chopper is feeding an RLE load. The condition for maximum ripple is
a = 1
a = 0.8
a = 0.5
a < 0.5
⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm
⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above
⇒ For the system in the given fi
y_{k} = u_{k} + 0.5 y_{k - 2}
y_{k} = u_{k} + 0.5 u_{k - 2}
y_{k} = u_{k} - 0.5 y_{k - 2}
y_{k} = u_{k} - 0.5 u_{k - 2}
⇒ Which of the following oscillator is not in FM?
Crystal oscillator
Hartley oscillator
Colpitts oscillator
All of the above
⇒ A network has 10 nodes and 17 branches. The number of different node pair are
7
9
10
45
⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE
⇒ In a klystron amplifier the force on all electrons
causes acceleration of all electrons
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above
⇒ In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port
10 mW
15 mW
20 mW
25 mW
⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE_{10} mode is
1.5 x 10^{8} m/s
5.5 x 10^{8} m/s
3.46 x 10^{8} m/s
0.18 x 10^{7} m/s
⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters
⇒ Which of the following devices should be used for accurate measurement of a low dc voltage?
Small range moving coil voltmeter
Dc potentiometer
Small range thermocouple voltmeter
Hot wire instrument
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ 9's complement of 56_{10} is
43_{10}
84_{10}
65_{10}
53_{10}
⇒ 9's complement of 12_{10} is
21_{10}
87_{10}
78_{10}
76_{10}
⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents
⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in
active region
saturation region
cut of region
inverted region
⇒ If t_{on} and t_{off} are the turn on and turn off times of a thyristor, then
t_{on} and t_{off} are almost equal
t_{on} >> t_{off}
t_{off} >> t_{on}
t_{on} is about twice t_{off}
⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3
⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content
⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses
⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63
⇒ If average correlation between v_{1}(t) and v_{2}(t) is R_{12}(t) and average correlation between v_{2}(t) and v_{1}(t) is R_{21}(t) then
R_{12}(t) = R_{21}(t)
R_{21}(t) = R_{12}(t)
R_{12}(t) = - R_{21}(t)
none of these
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt
⇒ Determine the voltage V_{CB} in the circuit bel
3.4 V
5.4 V
7.4 V
9.4 V
⇒ When an SCR is in forward blocking mode, the applied voltage
appears across only one junction
is equally shared by two junctions
is equally shared by three junctions
may appear across one or more junctions
⇒ Consider the following statements about polar plots
Both are correct
Both are wrong
1 is correct and 2 is wrong
2 is correct and 1 is wrong
⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)
⇒ The inverse Fourier transform of δ(t) is
∪(t)
1
δ(t)
e^{j2pt}
⇒ A dc chopper is feeding an RLE load. The condition for maximum ripple is
a = 1
a = 0.8
a = 0.5
a < 0.5
⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm
⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above
⇒ For the system in the given fi
y_{k} = u_{k} + 0.5 y_{k - 2}
y_{k} = u_{k} + 0.5 u_{k - 2}
y_{k} = u_{k} - 0.5 y_{k - 2}
y_{k} = u_{k} - 0.5 u_{k - 2}
⇒ Which of the following oscillator is not in FM?
Crystal oscillator
Hartley oscillator
Colpitts oscillator
All of the above
⇒ A network has 10 nodes and 17 branches. The number of different node pair are
7
9
10
45
⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE
⇒ In a klystron amplifier the force on all electrons
causes acceleration of all electrons
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above
⇒ In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port
10 mW
15 mW
20 mW
25 mW
⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE_{10} mode is
1.5 x 10^{8} m/s
5.5 x 10^{8} m/s
3.46 x 10^{8} m/s
0.18 x 10^{7} m/s
⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters
⇒ Which of the following devices should be used for accurate measurement of a low dc voltage?
Small range moving coil voltmeter
Dc potentiometer
Small range thermocouple voltmeter
Hot wire instrument
⇒
Assertion (A): An electronic tuner uses varactor diode
Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ 9's complement of 56_{10} is
43_{10}
84_{10}
65_{10}
53_{10}
⇒ 9's complement of 12_{10} is
21_{10}
87_{10}
78_{10}
76_{10}
⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents
⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in
active region
saturation region
cut of region
inverted region
⇒ If t_{on} and t_{off} are the turn on and turn off times of a thyristor, then
t_{on} and t_{off} are almost equal
t_{on} >> t_{off}
t_{off} >> t_{on}
t_{on} is about twice t_{off}
⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3
⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content
⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses
⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63
⇒ If average correlation between v_{1}(t) and v_{2}(t) is R_{12}(t) and average correlation between v_{2}(t) and v_{1}(t) is R_{21}(t) then
R_{12}(t) = R_{21}(t)
R_{21}(t) = R_{12}(t)
R_{12}(t) = - R_{21}(t)
none of these
⇒
Assertion (A): A video monitor does not need RF tuner and IF amplifier
Reason (R): The picture tube in TV is basically a CRT.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt
⇒ Determine the voltage V_{CB} in the circuit bel
3.4 V
5.4 V
7.4 V
9.4 V
⇒ When an SCR is in forward blocking mode, the applied voltage
appears across only one junction
is equally shared by two junctions
is equally shared by three junctions
may appear across one or more junctions
⇒ Consider the following statements about polar plots
- Addition of a non-zero pole to a transfer function results in further rotation of polar plot through an angle of - 90° as ω → ∞
- Addition of a pole at the origin to a transfer function rotates the polar plot at zero and infinite frequencies by a further angle of - 90°
Both are correct
Both are wrong
1 is correct and 2 is wrong
2 is correct and 1 is wrong