Question is ⇒ Which of the following real expressions is correct in Pascal?, Options are ⇒ (A) <code>- Z + P * X </code>, (B) <code>(X + Y) (A + B)</code>, (C) <code>Z ** M </code>, (D) <code>Z P * M</code>, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following real expressions is correct in Pascal?, Options are ⇒ (A) <code>- Z + P * X </code>, (B) <code>(X + Y) (A + B)</code>, (C) <code>Z ** M </code>, (D) <code>Z P * M</code>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following real expressions is correct in Pascal?
A.	`- Z + P * X` [Correct Answer]
B.	`(X + Y) (A + B)` [Wrong Answer]
C.	`Z ** M` [Wrong Answer]
D.	`Z P * M` [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The FM broadcast band is from
550 to 1600 kHz
88 to 108 kHz
88 to 108 MHz
1600 kHz to 59.75 MHz

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ For air filled circular waveguides
the attenuation due to imperfect conducting walls is negligible
the attenuation due to imperfect dielectric is negligible
both the attenuation i.e. due to imperfect conducting walls and due to imperfect dielectric are significant
the total attenuation is almost zero

⇒ Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is
TTL
CMOS
ECL
TTLLS

⇒ Digital television is also called
High digital television
High definition television
High deflection television
High display television

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ Two messages m₁, and m₂ have a probability of 0.5 each. The entropy is
0.25
0.5
0.75
1

⇒ The first contribution to logic was made by
George Boole
Copernicus
Aristotle
Shannon

⇒ In following figure find V_DSQ by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
4 V
- 6 V
- 10 V
6 V

⇒ In the circuit of figure, the power consumed in resistance R is measured when one source is acting at one time. These values are 18 W, 50 W and 98 W. When all source act together the maximum and minimum power ca
98 W and 18 W
166 W and 18 W
450 W and 2 W
166 W and 2 W

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒

Assertion (A): TTL uses multiple emitter transistor.

Reason (R): Multiple emitter transistors with about 60 emitters have been developed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ In the epitaxial diffused method of fabricating integrating circuits the process involved are __________

Epitaxial growth
Diffusion
Silicon diode growth
Vacuum evaporation of aluminium
Photoetching

The correct order is
1 - 2 - 3 - 4 - 5
1 - 3 - 5 - 2 - 4
3 - 1 - 4 - 5 - 2
1 - 3 - 2 - 4 - 5

⇒ Which of the following statement is correct?
Decimal 9 is represented as 1011 in Excess-3 code
Decimal 9 is represented as 1001 is BCD code
Decimal 10 is represented as 1100 is Gray code
Decimal 10 is represented as 1001 in binary code

⇒ The rating of a transformer to deliver 100 watts of D.C. power to a load under half wave rectifier will be nearly
1 kVA
350 VA
175 VA
108 VA

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ The Thevenin Resistance of the circui
94/7 kΩ
54/7 kΩ
7/54 kΩ
0

⇒ In setting up 'for' loops in Pascal, the initial and final values of index may be
integer constants
Integer constants or integer variable names
integer constants or integer variable names or integer expressions
integer constants or real constants

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
33.9 Hz
27.1 Hz
13.6 Hz
16.9 Hz

⇒ When a semiconductor bar is heated at one end, a voltage across the bar is developed. If the heated is positive the semiconductor is
P-type
n-type
intrinsic
highly degenerate

⇒

Assertion (A): Impedance matching can be done by using stubs.

Reason (R): A double stub is used for impedance matching when frequency of signal varies.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ For AM receivers the standard IF frequency is
106 kHz
455 kHz
1.07 MHz
10.7 MHz

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
5 V
10 V
15 V
30 V

⇒ Two coupled coils have self inductance L₁ and L₂. The coefficients of coupling is k. The mutual inductance is
k L₁L₂
k²L₁L₂
kL₁L₂
kL₁L₂

⇒ The correct form of expression B³ -2 A C in FORTRAN 77 is
B * * 3 - 2 * A * C
B * 3 - 2 * A AC
B * * 3 - 2 ** A * C
B *** 3 - 2 * A * C

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω