Question is ⇒ Which of the following circuit does not need a coupling capacitor?, Options are ⇒ (A) Resistance loaded, (B) Transformer coupled, (C) Impedance coupled, (D) Single tuned, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following circuit does not need a coupling capacitor?, Options are ⇒ (A) Resistance loaded, (B) Transformer coupled, (C) Impedance coupled, (D) Single tuned, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following circuit does not need a coupling capacitor?
A.	Resistance loaded [Wrong Answer]
B.	Transformer coupled [Correct Answer]
C.	Impedance coupled [Wrong Answer]
D.	Single tuned [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE

⇒ Drift velocity of electrons is generally less than 1 mm/s.
TRUE
FALSE

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ Which dc servomotor has minimum inertia?
Slotted armature construction
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ In radar display system PPI stands for
Pulse Position Indicator
Plan Position Indicator
Phase Position Indicator
Point Position Indicator

⇒

Assertion (A): ∈₀ has the dimensions of farad per meter.

Reason (R): D = ∈₀∈_r E.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A Wien bridge oscillator uses
negative feedback
positive feedback
both negative and positive feedback
none of the above

⇒

Assertion (A): Direct coupled amplifiers are rarely used

Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For radiating ultraviolet rays, LEDs use
zinc sulphide
gallium arsenide
gallium phosphide
none of the above

⇒ The maximum rectification efficiency in case of full wave rectifier is
1
0.812
0.666
0.406

⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement 13
16
9
14

⇒ In a JK master slave flip flop
master is clocked when clock is low
slave is clocked when clock is high
master is clocked when clock is high and slave is clocked when clock is low
master is clocked when clock is low and slave is clocked when clock is high

⇒ The assigned carrier frequency of an FM broadcast station is 96.3 MHz. Its FM signal has a centre frequency of
10 MHz
455 kHz
48.15 MHz
96.3 MHz

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto
from 0 to 1
from about 0.3 to 0.7
from 1 to 5
from 0 to 3

⇒ If a driving point function N(s) = p(s)/q(s), then
the degree of p(s) and q(s) may differ by one only
the degree of p(s) and q(s) may differ by zero only
the degrees of p(s) and q(s) be equal
the degrees of p(s) and q(s) must not be equal

⇒ Instruction cycle is the time required to complete the execution of an instruction.
TRUE
FALSE

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A volt ratio box should have low resistance.
TRUE
FALSE

⇒ In photoelectric emission the maximum kinetic energy of emitted electron is proportional to
f
f
f²
f³

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ The potential of suppressor grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ Laplace transform method enables us to find the response in
steady state
transient state
both steady and transient state
transient state provided forcing functions do not exist

⇒ The commonly employed filter in SSB generation is
high pass filter
RC filter
LC filter
mechanical filter

⇒ The current gain of a bipolar transistor drops at high frequencies because of
transistor capacitance
high current effects in the base
parasitic inductive elements
the early effect

⇒ If h₁[n] = 3δ[n] + δ[n - 1], h₂[n] = 2δ[n] + δ[n
{6, 18, 7, 4, 0, - 6, 9}
{9, 0, - 6, 21, 7, 6, 1}
{7, - 1, 3, 1, 7, 0, 6}
{9, - 6, 0, 1, 21, 7, 18, 6}

⇒ Among the various modulation systems, the most favoured from the point of linearity of modulation and efficiency is
anode or collector modulation
central grid modulation
screen grid modulation
modulated oscillators

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒ For ideal performance, a filter should be terminated in characteristic impedance.
TRUE
FALSE

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB