Question is ⇒ Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded. Reason (R): A high inverse voltage can destroy a p-n junction. , Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not a correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded. Reason (R): A high inverse voltage can destroy a p-n junction. , Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not a correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded. Reason (R): A high inverse voltage can destroy a p-n junction.
A.	Both A and R are true and R is correct explanation of A [Correct Answer]
B.	Both A and R are true but R is not a correct explanation of A [Wrong Answer]
C.	A is true but R is false [Wrong Answer]
D.	A is false but R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ A reactor is used in a dual converter operating in non-circulating current mode.
TRUE
FALSE

⇒ In a FM waveform, the side bands are spaced at intervals equal to
four times the modulating frequency
twice the modulating frequency
half the modulating frequency
modulating frequency

⇒ In orthogonal BFSK, the energy of information bearing term is
the same as total transmitted energy
one-half of total transmitted energy
one-fourth of total transmitted energy
none of the above

⇒ In satellite communication, frequency modulation is used because satellite channel has
small bandwidth and negligible noise
large bandwidth and severe noise
maximum bandwidth and minimum noise
high modulation index

⇒ In which of the following devices can the operation be visualised in terms of a series feedback loops?
TWT
Reflex klystron
Klystron amplifier
Backward wave oscillator

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ To study electromagnetic radiations from astronomical objects, radio astronomers use
low frequencies
medium frequencies
microwaves
either (a) or (b)

⇒ Wheatstone bridge is suitable for low resistances.
TRUE
FALSE

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ The normalised form of 0.0152 x 10¹⁸ is
0.152 x 10¹⁷
1.52 x 10¹⁶
15.2 x 10¹⁵
152 x 10¹⁴

⇒ Which characteristic of a memory chip is called ac characteristics?
Power consumption
Bus loading
Timing characteristic
All of the above

⇒ As the frequency increases, the absorption of ground wave by earth's surface
decreases
increases
remains the same
either (a) or (c)

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ Higher value of ripple factor indicates
poor rectification
ideal rectification
r.m.s. value to peak value
none of the above

⇒ In shot noise
the current rises around mean value
the current rises to peak value, decreases to zero and then again rises
the current may become negative
the current is always less than the mean value

⇒ The current flowing through the resistance R in the circuit in the figure has the form 2 cos 4t, where
(0.18 + j0.72)
(0.46 + j1.90)
- (0.18 + j1.90)
(0.23 - 0.35 j)

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ Which of the following statement regarding single-sideband (SSB) transmission is not correct?
In such transmission only or sideband is transmitted, leaving of the other sideband and the carrier
It has gained general acceptance of use in home-entertainment equipment
It is generally reserved for point-to-point communication
The amount of power and bandwidth necessary to be transmitted for a given amount of information are appreciable reduced

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ TTL XOR gate is very suitable as LCO driver.
TRUE
FALSE

⇒

Assertion (A): When cathode temperature is increased from 2500 K to 2550 K, thermionic emission current may increase by about 50%.

Reason (R): Thermionic emission current ∝ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): In p type semiconductor conduction is mainly due to holes.

Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°