Question is ⇒ The attenuation in a waveguide near the cut off frequency is, Options are ⇒ (A) zero, (B) low, (C) high, (D) very high, (E) , Leave your comments or Download question paper.

Question is ⇒ The attenuation in a waveguide near the cut off frequency is, Options are ⇒ (A) zero, (B) low, (C) high, (D) very high, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The attenuation in a waveguide near the cut off frequency is
A.	zero [Correct Answer]
B.	low [Wrong Answer]
C.	high [Wrong Answer]
D.	very high [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which binary subtraction is incorrect?
100101 - 100011 = 000000
10000000 - 01000000 = 1000000
10111110.1 - 101011.11 = 110010.11
11111111 - 1111111 = 10000000

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ Decimal 45.15 when converted into 9's complement will become
54.84
45.48
48.54
45.84

⇒ In a metal, the drift velocity of electrons in the presence of a electric field E is
proportional to E
proportional to E
inversely proportional to E
proportional to E²

⇒ For addition and subtraction operations, phasors
must be represented in polar form
must be represented in rectangular form
may be represented in any form
none of the above

⇒ In a series RLC circuit the phase angle θ of impedance Z ∠θ is positive. The circuit will behave as
resistive circuit
RC circuit
RL circuit
either RL or RC circuit

⇒ In the switching circuit, switches A, B have value 0 for OFF, 1 for ON and the output Y has 0 volts for 1 volts, then the expression for
AB
A + B
A + B
AB

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ An RC oscillator uses
one RC combination
two RC combinations
at least three RC combinations
either (a) or (b)

⇒ Which of the following is necessary transistor action?
The base region must be very wide
The base region must be very narrow
The base region must be made of some insulating material
The collector region must be heavily doped

⇒ A buffer amplifier is
a double-tuned amplifier
a high gain D.C. amplifier
a cathode follower stage
none of the above

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ Consider the followings statements: A multiplier

selects one of the several inputs and steers it to the output
routes the data from a single input to many outputs
converts parallel data into serial data
is a combinational circuit

On the above statements which are correct?
1, 2, 4
2, 3, 4
1, 3, 4
1, 2, 3

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ In figure, thyristor Th is in off state. When thyristor is turned on, the peak thyristor current can
0.208333333333333
0.416666666666667
15 A
20 A

⇒ A parallel plate capacitor having C = 200 x 10^-12 F has loss dielectric having tan δ = 4 x 10^-4. At an ac voltage of f = 10⁶ Hz and peak value 2 V, the dielectric losses are
10^-8 W
10^-6 W
10^-4 W
10^-2 W

⇒ A receiver having poor IF selectivity will also have poor
sensitivity
double spotting
blocking
all of the above

⇒

Assertion (A): For most metals, Fermi energy E_F is less than 10 eV.

Reason (R): Fermi level of a metal is given by E_F = 3.64 x 10^-19 (n)^2/3 where n is number of free electrons/m³ of metal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Decoder is not a combinational circuit.

Reason (R): Every memory element of semi conductor form has a decoder.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20

⇒ Divergence of curl A is
∇ . (∇ x A) = 1
∇ . (∇ x A) = 0
∇ . (∇ x A) = ∇
∇ . (∇ x A) = - ∞

⇒ The circuit shown in the figure conv
BCD to Binary code
Binary to excess - 3 code
Excess - 3 to Gray
Gray to Binary

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒ At half power frequencies the current in R-L-C series circuit is __________ times current at resonance
1/3
1/4
1/2
42737