Question is ⇒ Is the interrupt-enable flag?, Options are ⇒ (A) Low, (B) High, (C) Never, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ Is the interrupt-enable flag?, Options are ⇒ (A) Low, (B) High, (C) Never, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Is the interrupt-enable flag?
A.	Low [Wrong Answer]
B.	High [Correct Answer]
C.	Never [Wrong Answer]
D.	None [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minimum number of NAND gates required to implement the Boolean function A +AB + ABC is equal to
0
1
4
7

⇒

Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.

Reason (R): In a symmetrical matrix S_ij = S_ji.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ The Boolean function A + BC is a reduced form of
AB + BC
(A + B) . (A + C)
AB + ABC
(A + C) . B

⇒ As compared to 17.34° antenna, the total increase in the signal relayed by 4.5° antenna of INTELSAT-IV is
14.85
220
78
3.85

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ In single phase half wave regulator, the average current over one full cycle
is always positive
may be positive or negative
may be negative
is always negative

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ The Central Processing Unit (CPU) of the 16-processor system developed by hardware and software teams of C-DOT, Bangalore is configured around
Motorola 68020
Motorola 68040
Intel 80386
Intel 80486

⇒ In a colour TV receiver, the sound intercarrier IF is generated in
video detector
video IF amplifier
tuner mixer stage
limiter stage

⇒ For the two port of figure, z_{1126/7 Ω
10/3 Ω
6 Ω
2 Ω}

⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature

⇒ The first column of a Routh arra
2
3
4
5

⇒ A capacitor behave to d.c. as
short-circuit
an open-circuit
it behaves to a.c.
none of these.

⇒ In the below figure, the load is highly inductive. The firing angle is a for each of the thyristors. The periods of conduction of Th₁ and Th₂ respectively
0 to p and p to 2p
a to p and p + a to 2p
a to p + a and p + p to 2p + a
a to p - a and p + a to 2p - a

⇒ Industrial noise has the frequency range of
1 to 100 Hz
200 to 5000 Hz
above 200 MHz
1 to 600 MHz

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the first memory location?
AAAA
FFFF
AAA0
0

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ In the transformer shown in the figure, the inductance measured across the terminal 1 and 2 was 4 H with open terminals 3 and 4. It was 3H when the terminals 3 and 4 were short circuited. The coefficient of coupling woul
1
0.707
0.5
indetermine due to insufficient data

⇒ The instruction MVI A, 20 in 8085 means
contents of memory location 20 are brought into the accumulator
the value 20 is brought into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ As the number SWG increases, area of cross-section decreases.
TRUE
FALSE

⇒ In intrinsic semiconductor magnitude of free electron and hole concentrations are equal.
TRUE
FALSE

⇒ The force required to initiate motion between two contacting surfaces is called
coulomb friction
viscous friction
static friction
none of the above