Question is ⇒ The function of an AM detector circuit is to, Options are ⇒ (A) rectify the input signal, (B) discard the carrier, (C) provide audio signal, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The function of an AM detector circuit is to, Options are ⇒ (A) rectify the input signal, (B) discard the carrier, (C) provide audio signal, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The function of an AM detector circuit is to
A.	rectify the input signal [Wrong Answer]
B.	discard the carrier [Wrong Answer]
C.	provide audio signal [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 7 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ Symbol shown in figure represen
P-channel DMOSFET
N-channel DMOSFET
UJT with P-type base
UJT with N-type base

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR

⇒ Which of the following is not correct in C?
6 / 4 = 1
2 / 5 = 0
2.0 / 5 = 0
2.0 / 5.0 = 0.4

⇒ Consider a Binary Symmetric Channel (BSC) with probability of error being p. To transmit a bit, say 1, we transmit a sequence of three 1 s. The receiver will interpret the received sequence to represent 1 if at least two bits are 1. The probability that the transmitted bit will be received in error is
p³ + 3p² (1 - p)
p³
(1 - p)³
p³ + p² (1 -p)

⇒ The circuits with active pull up are preferred because of their stability for
wired - AND operation
wired - OR operation
bus operated system
reasonable dissipation and speed of operation

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒ The five flags in 8085 are designated as
Z, CY, S, P and AC
D, Z, S, P, AC
Z, C, S, P, AC
Z, CY, S, D, AC

⇒ A magnetron requires an external magnetic field with flux lines parallel to axis of cathode
TRUE
FALSE

⇒

Assertion (A): In 8085 SP and PC are 8 bit each.

Reason (R): 8085 is an 8 bit microprocessor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒

Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance R_E between emitter and ground

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ The widely used binary multiplication method is
repeated addition
add and shift
shift and add
any of the above

⇒ If a signal f(t) has energy E, the energy of the signal f(2t) is equal to __________ .
E
E/2
E/4
2E

⇒ A transmitter power of 10 W is increased by 30 dB. The effective radiated power is
100 W
1000 W
10000 W
100000 W

⇒

Assertion (A): A capacitor with imperfect dielectric can be represented by a capacitance in parallel with resistance.

Reason (R): For imperfect dielectrics, dielectric constant has real and imaginary parts.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In terrestrial microwave links, the number of 'fades' per unit increases as
both the transmission and the distance between the antennas are increased
the transmission frequency is increased but the distance between the antennas is decreased
the transmission frequency is decreased but the distance between the antennas is increased
both the transmission frequency and distance between the antennas are decreased

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ Which of the following noise becomes of great importance at high frequencies?
Shot noise
Agitation noise
Flicker noise
Transit time noise

⇒ A pair of 21114s can store __________ words of __________ bits each.
2114, 8
1024, 8
4228, 16
2114, 16

⇒ A moving iron instrument can be used for
dc only
ac only
both dc and ac
dc and high frequency ac

⇒ A Darlington pair consist of
two CB amplifiers
two CC amplifiers
two cascaded CC amplifiers
two cascaded CE amplifiers

⇒ Which configuration has high input impedance and low output impedance?
CB
CE
CC
CB and CE

⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC