Question is ⇒ The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by, Options are ⇒ (A) A ← A + B, (B) A ← AB, (C) A ← A + B, (D) A ← AB, (E) , Leave your comments or Download question paper.

Question is ⇒ The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by, Options are ⇒ (A) A ← A + B, (B) A ← AB, (C) A ← A + B, (D) A ← AB, (E) , Leave your comments or Download question paper. AB, (C) A ← A + B, (D) A ← AB, (E) , Leave your comments or Download question paper. '/> AB, (C) A ← A + B, (D) A ← AB, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by
A.	A ← A + B [Wrong Answer]
B.	A ← AB [Wrong Answer]
C.	A ← A + B [Wrong Answer]
D.	A ← AB [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal.

Reason (R): Emitter base junction in BJT is forward biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ In LIFO
only the top of the stack is immediately accessible
only the top of the stack is never accessible
only the first-in is accessible
only the first-in is not accessible

⇒ Bellows converts
pressure difference into displacement
pressure difference into voltage
displacement into pressure difference
either (a) or (c)

⇒ The absorption of EM wave by the atmosphere depends on
polarization of waves
frequency in use
dist. from T_y
height of antenna

⇒ In a second order system, peak overshoot is independent of
damping factor
natural frequency
both damping factor and natural frequency
neither damping factor nor natural frequency

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ Indium, aluminium, arsenic are all p type impurities.
TRUE
FALSE

⇒ DC ampere hour meter is an indicating instrument.
TRUE
FALSE

⇒ For pole-zero plot shown, the system is ________
minimum phase
maximum phase
mixed phase
none of these

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ Minute cracks in metals and minute faults in welded joints can be detected using
IR rays
UV rays
a rays
X-ray/γ-rays

⇒ If each frequency component of f(t) is shifted by p/2, the resulting signal is
Hilbert transform of f(t)
Inverse Hilbert transform of f(t)
Laplace transform of f(t)
Fourier transform of f(t)

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
0.34
0.555
0.688
0.847

⇒ In figure, V_{AB6 V
10 V
25 V
40 V}

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ The distance between target and radar is reduced to half. Power received increases by
42751
42739
4 times
16 times

⇒ In a shift left register, shifting a bit by one bit means
division by 2
multiplication by 2
subtraction of 2
None of the above

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒

Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A line has Z₀ = 300 ∠ 0° Ω. If Z_L = 150 ∠ 0° Ω, reflection coefficient is
0.5
0.3333
-0.3333
-0.5

⇒ Consider the transmission line of length 37.5 cm, which is terminated into zero resistance. This line is being exited by a source of 1 GHz which has an internal impedance of 50 Ω. What is the input impedance of the line as seen by the source?
50 Ω
Zero Ω
100 Ω
Infinite Ω

⇒ AM transmitter employing low level modulation
uses class C amplifier for amplification
requires higher audio power
has a poor efficiency
has a higher efficiency

⇒ In a purely inductive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ Radiowaves are electromagnetic waves having frequency range
0.001 to 50 H
0.001 to 50 kHz
0.002 to 50 MHz
0.001 to 10¹⁶ Hz

⇒ Which of the following is not a general purpose peripheral?
I/O port
Programmable interrupt controller
Programmable CRT controller
Programmable interval timer

⇒ Consider the following statements about Yagi Uda antenna

It is unidirectional
Its gain is about 7 dB
It is used at VLF
The optimum separation is 0.11

Which of the above are correct?
1 and 2 only
1, 2, 4 only
1, 2, 3, 4
1 and 4 only