Question is ⇒ For the circuit shown in the following figure I0-I3 are inputs to the 4:1 multiplexer R(MSB) and S are control, Options are ⇒ (A) PQ + PQ S + Q R S, (B) P Q + PQ R + P Q S, (C) P Q R + P QR + PQRS + Q R S, (D) PQ R + PQR S + P Q R S + Q R S, (E) , Leave your comments or Download question paper.

Question is ⇒ For the circuit shown in the following figure I0-I3 are inputs to the 4:1 multiplexer R(MSB) and S are control, Options are ⇒ (A) PQ + PQ S + Q R S, (B) P Q + PQ R + P Q S, (C) P Q R + P QR + PQRS + Q R S, (D) PQ R + PQR S + P Q R S + Q R S, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
A.	PQ + PQ S + Q R S [Wrong Answer]
B.	P Q + PQ R + P Q S [Correct Answer]
C.	P Q R + P QR + PQRS + Q R S [Wrong Answer]
D.	PQ R + PQR S + P Q R S + Q R S [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ The main advantage of TDM over FDM is that it
needs less power
needs less bandwidth
needs simple circuitry
gives better S/N ratio

⇒ The output data lines of microprocessor and memories are usually tristated because
more than one device can transmit information over the data bus by enabling only one device at a time
more than one device can transmit information over the data bus at the same time
the data lines can be multiplexed for both I/P and O/P
it increases the speed of data transfers over the data bus

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒ In metals, the flow of current is due to
electrons
ions
holes
electrons and ions

⇒ Which of the following is not a valid variable name in C?
p o, t
p o t
po_t
p_ot

⇒ In a receiver, at higher frequencies
tracking will be improved
tracking will be poor
selectivity will be poor
image frequency rejection will be poor

⇒ Minute cracks in metals and minute faults in welded joints can be detected using
IR rays
UV rays
a rays
X-ray/γ-rays

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ The enhancement type MOSFET is called a
normally on MOSFET
normally off MOSFET
P-type MOSFET
N-type MOSFET

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ For a particular type of memory the access time and cycle time are 200 ns each. The maximum rate at which data can be accessed by
2.5 x 10⁶/s
5 x 10⁶/s
0.2 x l0⁶/s
10⁶/s

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ Binary 1111 when added to binary 11111, the result in binary is
111111
1111
1000
10000

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ If the resolution of a printer is 1200 dpi, the number of dots per square inch is
1200
800
1200 x 1200
either (a) or (b)

⇒ In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ In a digital voltmeter the oscillator frequency is 400 kHz and the ramp voltage falls from 8 V to 0 V in 20 ms. What is the number of pulses counted by the counter?
800
2000
4000
8000

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ An 8 bit DAC has a full scale output of 2 mA and full scale error of ± 0.5%. If input is 10000000 the range of outputs is
994 to 1014 μA
990 to 1020 μA
800 to 1200 μA
none of the above

⇒ How many input-output ports can be accessed by direct method of 8085 μp?
8
256
32 K
64 K

⇒ An ideal op-amp requires
zero input offset voltage
low input offset voltage
high input offset voltage
infinite input offset voltage

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz