Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Characteristics) </th> <th width="5%"></th><th>List II (Device) </th></tr><tr><td>A.</td><td>Voltage controlled device</td><td>1.</td><td>BJT</td></tr><tr><td>B.</td><td>Current controlled device</td><td>2.</td><td>UJT</td></tr><tr><td>C.</td><td>Conductivity modulation device</td><td>3.</td><td>FET</td></tr><tr><td>D.</td><td>Negative conductance device</td><td>4.</td><td>Impatt diode</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-3, C-1, D-1, (B) A-2, B-3, C-4, D-1, (C) A-3, B-1, C-2, D-4, (D) A-3, B-1, C-4, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Characteristics) </th> <th width="5%"></th><th>List II (Device) </th></tr><tr><td>A.</td><td>Voltage controlled device</td><td>1.</td><td>BJT</td></tr><tr><td>B.</td><td>Current controlled device</td><td>2.</td><td>UJT</td></tr><tr><td>C.</td><td>Conductivity modulation device</td><td>3.</td><td>FET</td></tr><tr><td>D.</td><td>Negative conductance device</td><td>4.</td><td>Impatt diode</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-3, C-1, D-1, (B) A-2, B-3, C-4, D-1, (C) A-3, B-1, C-2, D-4, (D) A-3, B-1, C-4, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1

A-2, B-3, C-4, D-1

A-3, B-1, C-2, D-4

A-3, B-1, C-4, D-2

View Answer 1 -1

Explanation:-
Answer : D
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a good conducting medium the intrinsic impedance is
σωμ ∠p/2
ωμ /σ ∠45°
ωμ/σ ∠p/2
ωμ/σ ∠0°

⇒ In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is
serial in-serial out
parallel in-serial out
serial in-parallel out
parallel in-parallel out

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ In figure, i(0^-) and v(0^-) are zero. The switch is closed at t = 0, i(0⁺) and (∞)
3 A and 1.5 A
1.5 A and zero
3 A and zero
1.5 A and 3 A

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ A P-N junction offers
high resistance in forward as well as reverse direction
low resistance in forward as well as reverse direction
conducts in forward direction only
conducts in reverse direction only

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ A failure rate of 0.01 percent in 1000 hours in a memory corresponds to an MTBF of
1000 hours
100000 hours
10 hours
100 hours

⇒ Which of the following is true?
Intel 8080 was the ancestor of Intel 8085
Intel 8080 was the ancestor of Intel Z 80
Intel 8080 was the ancestor of both Intel 8085 and Z 80
Intel 8085 was the ancestor of Intel 8085

⇒

Assertion (A): If a wave v = A₁ + A₂ sin ωt is applied to a pure capacitor the current wav
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ The principal of locality of reference justifies the use of
interrupts
DMA
virtual memory
cache memory

⇒ A gate function which occurs at t = t₀ and lasts for duration T can be written as
u (t - t₀ - T)
u(t - t₀) = u(t - t₀ - T)
u(t - t₀) - u(t - t₀ - T)
u(t - t₀) - u(t - t₀ + T)

⇒ What will be the maximum conversion time in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
108 sec
63 μ sec
40 sec
80 μ sec

⇒ In case of stabilized reactance modulator AFC system
phase modulator is converted into frequency modulation by equalizer circuit
the discriminator must have a fast time constant to provide demodulation
the higher discriminator frequency, the better oscillator frequency
the discriminator frequency must be too low, or the system will fail

⇒ The dependent current source shown in given fig
delivers 80W
absorbs 80W
deliver 40W
absorbs 40W

⇒ Consider the following statement associated with bipolar junction transistor and JFET

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ An LED is
an ohmic device
a display device
a voltage regulated device
all of the above

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ Vividh Bharati programme is transmitted in
short wave
medium frequency
very high frequency
all of the above

⇒ The term 'energy spectral density' is associated with
periodic waveform
non-periodic waveform
both perodic and non -perodic waveform
none of the above

⇒ For a P-N diode, the number of minority carriers crossing the junction depends on
forward bias voltage
potential barrier
rate of thermal generation of electron hole pairs
none of the above

⇒ Which of the following is a valid FORTRAN assignment statement?
10 = N
X + 2.1 = 5.6
A = B
A = B = 1

⇒ The M circle for M = 1 is the
straight line at x = - 0.5
critical point (-l, jo)
circle with r = 0.33
circle with r = 0.67

⇒ In a superheterodyne radio receiver
RF amplifier normally operates at 455 kHz above carrier frequency
mixer input must be tuned to the signal frequency
local oscillator operates below signal frequency
local oscillator frequency is double the IF