Question is ⇒ Which of the following is a disadvantage of Vestigial Sideband (VSB) system?, Options are ⇒ (A) Low video frequencies are attenuated, (B) Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system, (C) It results in a power boost of two video frequencies, (D) It possess the advantages of both DSB and SSB system, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is a disadvantage of Vestigial Sideband (VSB) system?, Options are ⇒ (A) Low video frequencies are attenuated, (B) Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system, (C) It results in a power boost of two video frequencies, (D) It possess the advantages of both DSB and SSB system, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is a disadvantage of Vestigial Sideband (VSB) system?
A.	Low video frequencies are attenuated [Wrong Answer]
B.	Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system [Wrong Answer]
C.	It results in a power boost of two video frequencies [Correct Answer]
D.	It possess the advantages of both DSB and SSB system [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ TV signal strength when expressed in dB m has the reference of
10 μV/m
5 μV/m
2 μV/m
1 μV/m

⇒ The symbol in figure is
SUS
SBS
Shockley diode
UJT

⇒ A PC has typically
5 to 10 KB of main memory
10 to 100 KB of main memory
100 to 256 KB of main memory
256 KB to 1 MB of main memory

⇒ Resistivity of copper is nearly
1.56 μ ohm-cm
3.95 μ ohm-cm
14.55 μ ohm-cm
22.05 μ ohm-cm

⇒ For a series RLC circuit bandwidth is ω₂ - ω₁ = R/2L.
TRUE
FALSE

⇒ In 8085 microprocessor, which of the following interrupts has the lowest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ Two messages m₁, and m₂ have a probability of 0.5 each. The entropy is
0.25
0.5
0.75
1

⇒ In carbon resistor colour code, if the third band is of silver, it indicates
that three zeros are to be added to indicate the resistance value
multiplier is 0.01
multiplier is 0.1
tolerance is ± 5%

⇒

Assertion (A): Wien bridge can be used for measuring frequency.

Reason (R): A frequency meter for 50 Hz system has a frequency range of 40 to 60 Hz.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is
1250
330
2500
8330

⇒ Frequencies in the UHF range propagate by means of
space wave
surface waves
sky waves
ground waves

⇒ The circuit of the given figure perf
OR function
AND function
exclusive OR function
exclusive NOR function

⇒ Which one most appropriate dynamic system?
y(n) + y(n - 1) + y(n + 1)
y(n) + y(n - 1)
y(n) = x(n)
y(n) + y(n - 1) + y(n + 3) = 0

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ The selectivity of most receivers is determined largely by
sensitivity
characteristics of IF section
antenna direction
all of the above

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ The main drawbacks of EEPROM are
low density
high cost
both low density and high cost
none of the above

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency is
100 rad/sec
10000 rad/sec
1000 rad/sec
more than 10000 rad/sec

⇒ The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about
1200 Ω
120 Ω
600 Ω
10 Ω

⇒

Assertion (A): A backward wave oscillator can be used as a sweep generator.

Reason (R): The frequency of oscillation of a backward wave oscillator can be changed by varying the voltage which controls the beam velocity.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If L [f(t)] = F(s), Lf(t - T)
e^sTF(s)
e^-sTF(s)
F(s) - e^-sT
F(s) + e^-sT

⇒ Out of the three transforms viz. Z-transform, Laplace transform and Fourier transform
all three are used in continuous time domain
all three are used in both continuous time domain and discrete time domain
Z transform is used in continuous time domain while Laplace and Fourier transforms are used in discrete time domain
Z transform is used is discrete time domain while Laplace and Fourier transforms are used in continuous time domain

⇒

Assertion (A): In 8085, P flag is for parity checking.

Reason (R): If the result of ALU has even parity, P flag is set and if the result has odd parity, P flag is reset.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statements is not correct?
Propagation delay is the time required for a gate to change its state
Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state
Fan-in of a gate is always equal to fan-out of the same gate
Operating speed is the maximum frequency at which digital data can be applied to a gate

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ The message carrying efficiency is best in
AM
FM
AM-SC
Phase modulation

⇒ The damping coefficient for the given circuit is _______
42737
42739
2
1