Question is ⇒ Inductors used at V.H.F. are made using, Options are ⇒ (A) air core, (B) cast iron cored, (C) sheet steel cored, (D) thin film technique, (E) , Leave your comments or Download question paper.

Question is ⇒ Inductors used at V.H.F. are made using, Options are ⇒ (A) air core, (B) cast iron cored, (C) sheet steel cored, (D) thin film technique, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Inductors used at V.H.F. are made using
A.	air core [Wrong Answer]
B.	cast iron cored [Wrong Answer]
C.	sheet steel cored [Wrong Answer]
D.	thin film technique [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ TV receivers use flyback switched mode power supply because
it can supply many voltage outputs
it does not require a filter choke and is cheap
it has very good regulation at all loads
both (a) and (c)

⇒ The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
(t^2* e^-2t) U(t)
(t^* e^2t) U(t)
(te^-2t) U(t)
(te^2t) U(t)

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ The relaxation time of electrons in a metal is of the order of
10^-6 secs
10^-10 secs
10^-14 secs
10^-20 secs

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ Geosynchronous communication satellites travel around the earth in circular orbits with a forward speed of about __________ km/h.
11200
0
36000
22800

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒ Radio broadcasts are generally
amplitude modulation
frequency modulation
both amplitude and frequency modulation
neither amplitude nor frequency modulation

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current through
0.166666666666667
2.5 A
3.1 A
0

⇒ An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
sine wave
square wave
triangular wave
(a) or (c)

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ Generally a servomotor operates at
high torque and high speed
low torque and low speed
low torque and high speed
high torque and low speed

⇒ If a EM wave propagating in z direction then
component of EM wave will exist in z direction
component of EM wave will not exist in z direction
component of EM wave will exist in y direction
component of EM wave will exist in x direction

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz
6.28
62.8
8
0

⇒

Assertion (A): In a push pull circuit each transistor stays in the active region for one half cycle

Reason (R): A push pull amplifier has low distortion

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In CE connection, the leakage current of a transistor is about
10 x 10^-9 A
5 x 10^-6 A
200 x 10^-6 A
5 x 10^-3 A

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
2 f
f
0.5 f
0.25 f

⇒ The h parameter h₁₁ is the same in CE and CC circuit.
TRUE
FALSE

⇒ According to maximum power transfer theorem, the maximum power is absorbed by one network from another network when
the impedance of one of the networks is half that of the other
the impedance of one is the complex conjugate of the other
the impedance of one is equal to that of the other
none of the above

⇒ In 8085 microprocessor, what is the length of IR (instruction register)?
6 bits
8 bits
12 bits
16 bits

⇒ In Java which operator can be used even if there is a single operand
+
-
*
%

⇒ The magnetization 'm' of a superconductor in a field of H is
extremely small
- H
-1
Zero

⇒ Higher order TDM levels are obtained by
forming super master groups
using A law
using μ law
dividing pulse width

⇒ In a JFET the width of channel is controlled by
gate voltage
drain current
source current
all of the above

⇒ A 24 mm long conductor has a resistance of 128 Ω. The change in resistance is 13.3 Ω and change in length is 1.6 mm under tension. The gauge factor is
1.2
1.6
2.1
2.6

⇒ Sulphur hexafluoride is used in
transformers
generators
relays
circuit breakers

⇒

Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing.

Reason (R): During turn on the reverse biased junction in SCR breaksdown.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct