Question is ⇒ The input to integrating op-amp is a rectangular wave. The output will be, Options are ⇒ (A) a sine wave, (B) a rectangular wave, (C) a triangular wave, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The input to integrating op-amp is a rectangular wave. The output will be, Options are ⇒ (A) a sine wave, (B) a rectangular wave, (C) a triangular wave, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The input to integrating op-amp is a rectangular wave. The output will be
A.	a sine wave [Wrong Answer]
B.	a rectangular wave [Wrong Answer]
C.	a triangular wave [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ The ROC of sequence x[n] = (0.8)ⁿ ∪[n] + (0.4)ⁿ ∪[n]
|z| > 0.8
|z| > 0.4
0.4 < |z| < 0.8
|z| < 0.8

⇒ Which of the following microphones has lowest output impedance?
Moving coil
Ribbon
Crystal
Condenser

⇒ Which of the following is not used as a microwave mixer or detector?
PIN diode
Crystal diode
Schottky barrier diode
Backward diode

⇒ For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (V_SB > 0), the threshold voltage V_T of the MOSFET will
remain unchanged
decrease
change Polarity
increase

⇒

Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.

Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of inputs and outputs in a full adder are
2 and 1
2 and 2
3 and 3
3 and 2

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Reception through space wave is limited to line of sight distance.
TRUE
FALSE

⇒ The function of blend control in stereo system is
to dilute left channel
to dilute right channel
to dilute any of the channels
none of the above

⇒

Assertion (A): Direct coupled amplifiers are rarely used

Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.
TRUE
FALSE

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ Which one is correct statement?

Circuit is always open
Network is always open
Circuit is always closed
Network is always closed

1, 2
2, 3
3, 4
1, 4

⇒ The method used to transfer data from I/O units to memory by suspending the memory-CPU data transfer for one memory cycle is called
I/O spooling
Cycle stealing
Line conditioning
Demand paging

⇒ A 0-200 V voltmeter has an accuracy of 0.75% of full scale reading. If voltage measured is 100 V, the error is
0.03
0.02
0.015
0.0075

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ A 3 input NAND gate is to be used as inverter. Which of the following will give better results?
The two unused inputs are left open
The two unused inputs are connected to 0
The two unused inputs are connected to 1
None of the above

⇒ JFET is also known as
linear device
square law device
inverse law device
logarithmic law device

⇒ The modulation index is, if f_m = 500 Hz, Δf = 2.25 kHz
2.25
4.5
9
18

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): A synchro control transformer has nearly constant impedance across its rotor terminals.

Reason (R): Rotor of a synchro control transformer is cylindrical so as to give uniform flux distribution.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ In a CE amplifier circuit the load resistance is open circuited. The output voltage will
increase
decrease
become zero
increase or decrease