Question is ⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to, Options are ⇒ (A) electron, (B) doping, (C) thermal energy, (D) free electrons, (E) , Leave your comments or Download question paper.

Question is ⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to, Options are ⇒ (A) electron, (B) doping, (C) thermal energy, (D) free electrons, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
A.	electron [Wrong Answer]
B.	doping [Wrong Answer]
C.	thermal energy [Correct Answer]
D.	free electrons [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
13.5 m
3 m
88/3 m
3/88 m

⇒ The mass of an electron is nearly
9.1 x 10^-27 kg
9.1 x 10^-29 kg
9.1 x 10^-31 kg
9.1 x 10^-35 kg

⇒ Short-circuited stubs are preferred to open circuited stubs because the latter are
more difficult to make and connect
incapable of giving a full range of reactances
made of transmission line with a different characteristic impedance
liable to radiate

⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
252 sin (20000t + 45°)
252 sin (20000t - 45°)
252 sin 20000t
252 sin (20000t - 90°)

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒

Assertion (A): The capacitance of a reverse biased pin diode is lower than that of reverse biased p-n diode.

Reason (R): A PIN diode has an intrinsic layer between p and n regions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒ The core of a coil has a length of 10 cm. The self inductance is 8 mH. If the core length is doubled, all other quantities remaining the same, the self inductance will be
32 mH
16 mH
8 mH
4 mH

⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are
Triple Transistor Logic and Chip Metal Oxide Semiconductor
Tristate Transistor Logic and Chip Metal Oxide Semiconductor
Transistor Transistor logic and Complementary Metal Oxide Semiconductor
Trisate Transistor Logic and Complementary Metal Oxide Silicon

⇒ In drawing phasor diagram
rms values are used
peak values are used
either rms or peak values are used
either rms or peak or averages values are used

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = f_c, the characteristic impedance will be
zero
∞
300 Ω
more than 300 Ω

⇒ Probability of error in DPSK is less than PSK
TRUE
FALSE
equal
depend upon noise

⇒ In a transmission line terminated with a load equal to the characteristic impedance, the reflection coefficient is
0
1
-1
Infinity

⇒

Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ If the thermal resistance of a transistor is lower it means
higher junction temperature
lower junction temperature
higher or lower junction temperature depending on circuit conditions
higher or lower junction temperature depending on transistor

⇒ For the circuit shown in the figure, the capacitor C is initially uncharged. At t = 0, the switch S is closed. The voltage V_c across the capacitor at t = 1 millisecond is (In the figure shown above, the op-amp is supplied with ± 15 V and the ground has been shown by the sym
0 V
6.3 V
9.45 volts
10 volts

⇒ Which of the following is true?
SOP is a two level logic
POS is a two level logic
Both SOP and POS are two level logic
Hybrid function is two level logic

⇒ For a low level AM system, the amplifiers modulated stage must be
linear devices
harmonic devices
class C amplifiers
non-linear devices

⇒ Which of the following is true?
A silicon wafer heavily doped boron is a p⁺ substrate
A silicon wafer lightly doped boron is a p⁺ substrate
A silicon wafer heavily doped arsenic is a p⁺ substrate
A silicon wafer lightly doped arsenic is a p⁺ substrate

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ Which statement out of the following statement is wrong?
Attenuation of satellite signals by rain and fog varies almost inversely with the angle of elevation
At 12/4, GHz link frequencies, signal power loss due to rain and fog is much greater than at 4/6 GHz frequencies
The distance between satellite and Earth station varies slightly with angle of elevation
At present 4/6 GHz geostationary satellites are being parked in geosynchronous, orbits at least 10° apart

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler

⇒ In carbon resistor colour code, the third band is red. It indicates
two zeros
three zeros
multiplier is 0.01
multiplier is 0.1

⇒ A broadside array is shown in figure in which the elements are placed at equal distances. The direction of maximum radiation is represented
AA
BB
CC
DD

⇒ Let f₁(t) = G₁(t) + 4, f₂(t) = G₂(t) + 3. If G₁(t) and G₂(t) are uncorrected then the correlation between f₁(t) and f₂(t) are
12
7
6
zero

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE