Question is ⇒ A conductor carries 10 A current in + x direction and is lying in a field having a flux density 0.2 T directed along + z direction. The magnitude of force per metre length and direction are, Options are ⇒ (A) 2 N, + y direction, (B) 2 N, - y direction, (C) 0.02 N, + y direction, (D) 0.02 N, - y direction, (E) , Leave your comments or Download question paper.

Question is ⇒ A conductor carries 10 A current in + x direction and is lying in a field having a flux density 0.2 T directed along + z direction. The magnitude of force per metre length and direction are, Options are ⇒ (A) 2 N, + y direction, (B) 2 N, - y direction, (C) 0.02 N, + y direction, (D) 0.02 N, - y direction, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A conductor carries 10 A current in + x direction and is lying in a field having a flux density 0.2 T directed along + z direction. The magnitude of force per metre length and direction are
A.	2 N, + y direction [Wrong Answer]
B.	2 N, - y direction [Correct Answer]
C.	0.02 N, + y direction [Wrong Answer]
D.	0.02 N, - y direction [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ The number of comparator circuits required to build a three-bit simultaneous A/D converter is
7
8
15
16

⇒ Characteristic impedance of a coaxial cable is inversely proportional to ∈_r.
TRUE
FALSE

⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has
16 bit registers and 32 bit data bus
16 bit registers and 16 bit data bus
32 bit registers and 32 bit data bus
32 bit register and 16 bit data bus

⇒ If R_T, R_h represent condition for reciprocity in case of transmission parameter and hybrid parameter respectively and similarly S_T, S_h represent condition for symmetry in case of transmission parameter and hybrid parameter respectively then match the followi
1 - c 2 - d 3 - a 4 - f
1 - c 2 - b 3 - e 4 - d
1 - e 2 - d 3 - a 4 - b
1 - e 2 - d 3 - a 4 - f

⇒ Filter method and phasing method are the methods for generating
SSB signal
vestigial side band signal
both SSB and vestigial sideband signals
none of the above

⇒ The basic circuit configuration for TTL resembles that of a
AND gate
NAND gate
NOR gate
OR gate

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒

Assertion (A): A half cycle of sine wave can be expressed as sum of sine wave and another sine wave shifted by T/2 where T is the time period.

Reason (R): The function u(t - t₀) - u(t - t₀ - T) is a gate function occuring at t = t₀ and of duration T.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ In 3 phase power measurement by two wattmeter method, the reading of one wattmeter is zero. The power factor of load is
1
0.5
0
0.8

⇒

Assertion (A): A p-n junction is used as rectifier.

Reason (R): A p-n junction has low resistance in forward direction and high resistance in reverse direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ CD4010 is a
inverting buffer
non-inverting hex buffer
NOR IC
NAND IC

⇒

Assertion (A): Derivative control action is also called rate control and has an anticipatory character.

Reason (R): Derivative control amplifies noise signals.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Highest value of Autocorrelation of a function 100 cos 50 pt is
50
100
zero
100/p

⇒ 8085 has 6 sign flags.
TRUE
FALSE

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ In a TV studios, flying spot scanner is a device for
mixing video and audio signals
telecasting feature films
live telecast of outdoor programs
telecast of indoor music programs

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ The maximum number of characters for variable names in C is
4
8
12
16

⇒ The output of a diode detector contains
D.C. voltage
modulating signal
RF ripple
all of the above

⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
increases
decreases
may increase or decrease
remains the same

⇒ The ac collector current is nearly equal to
ac base current
ac signal current
ac supply current
ac emitter current

⇒ When the i-v curve of a photodiode passes through origin the illumination is
maximum
minimum
zero
equal to rated value