Question is ⇒ In low pass filter of figure R<sub>0</sub> = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C, Options are ⇒ (A) 1 H and 2 F, (B) 1 H and 1 F, (C) 2 H and 1 F, (D) 1 H and 2 F, (E) , Leave your comments or Download question paper.

Question is ⇒ In low pass filter of figure R<sub>0</sub> = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C, Options are ⇒ (A) 1 H and 2 F, (B) 1 H and 1 F, (C) 2 H and 1 F, (D) 1 H and 2 F, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
A.	1 H and 2 F [Wrong Answer]
B.	1 H and 1 F [Wrong Answer]
C.	2 H and 1 F [Wrong Answer]
D.	1 H and 2 F [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses

⇒ The number of bits in a nibble is
8
4
2
16

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ Consider the following statements:

In the 2's complement representation, negative numbers are stored in sign magnitude form.
Taking 2's complement is equivalent to sign change.
In a 4 bit complement representation of a binary number A.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.

Of these, the only true statements are
(I) and (III)
(I) and (IV)
(II) and (III)
(II) and (IV)

⇒ Two impedances 10 - j 10 and 10 + j 10 are connected in parallel. Their combined impedance is
5 + j5
5 - j5
10 + j0
20 - j10

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ An ungrounded antenna near the ground
is horizontally polarized
acts as an antenna array
acts as a single antenna of twice the height
is not likely to need an earth mat

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Poynting vector is associated with which of the following?
Power flow in electromagnetic
Flux in magnetic field
Charge in electrostatic field
Current in electrostatic field

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ Two similar coupled coils are connected in series. The total inductance in series aiding connection is 100 mH. If currents is 3 A, the energy stored in magnetic field is
0.9 J
0.45 J
0.225 J
1.8 J

⇒ The static equalisation circuit for thyristors connected in series is
one resistor in series with each thyristor
one resistor in parallel with each thyristor
one resistor and one capacitor in parallel with each thyristor
none of the above

⇒ The most common method for biasing a JFET is
reverse bias
self bias
voltage divider bias
none of the above

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers

⇒ Digital circuits mostly use
Diodes
Bipolar transistors
Diodes and bipolar transistors
Bipolar transistors and FETs

⇒ The distance of poles from origin depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ MTSO stands for
Metropolitan Telecommunication Subscribers Office
Metropolitan Telecommunication Switching Office
Mobile Telecommunication Switching Office
Mobile Telecommunication Subscriber Office

⇒ An ideal power supply has
zero internal resistance
very high internal resistance
high output resistance
both (b) and (c)

⇒ Wood is a diamagnetic material.
TRUE
FALSE

⇒ Which of the following pairs of octal and binary numbers are not equal?
111 11011₂ = 767₈
110110101₂ = 665₈
11010₂ = 3₈
10101.11₂ = 25.6₈

⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
2 f
f
0.5 f
0.25 f

⇒ 1101₂ - 1001₂ =
1000
100
10
1

⇒ The total field developed by an antenna array at a distant point is
phasor sum of fields produced by individual antennas of the array
algebraic sum of fields produced by individual antennas of the array
either (a) or (b) depending on type of array
neither (a) nor (b)

⇒ In a synchro transmitter
input is angular position of rotor shaft and output is stator voltages
input is stator voltages and output is angular position of shaft input is rotor voltage and output is angular position of rotor shaft
input is rotor voltage and output is angular position of rotor shaft
input is angular position of rotor shaft and output is rotor voltage

⇒ Identical telephone numbers in different parts of a country are distinguished by their
area codes
office codes
access digits
language codes