Question is ⇒ What are the values of Emax and Emin displayed on the oscilloscope, when a 1 kV P-P carries is modulated to 50%?, Options are ⇒ (A) 2 kV, 0.5 kV, (B) 1 kV, 0.5 kV, (C) 0.75 kV, 0.25 kV, (D) 0.5 kV, 1.5 kV, (E) , Leave your comments or Download question paper.

Question is ⇒ What are the values of Emax and Emin displayed on the oscilloscope, when a 1 kV P-P carries is modulated to 50%?, Options are ⇒ (A) 2 kV, 0.5 kV, (B) 1 kV, 0.5 kV, (C) 0.75 kV, 0.25 kV, (D) 0.5 kV, 1.5 kV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What are the values of E_max and E_min displayed on the oscilloscope, when a 1 kV P-P carries is modulated to 50%?
A.	2 kV, 0.5 kV [Wrong Answer]
B.	1 kV, 0.5 kV [Wrong Answer]
C.	0.75 kV, 0.25 kV [Correct Answer]
D.	0.5 kV, 1.5 kV [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The range of floating point numbers in Java is
1.4 E - 45 to 3.4 E + 38
3.4 E - 45 to 1.4 E + 38
1.4 E - 38 to 3.4 E + 45
3.4 E - 38 to 1.4 E + 45

⇒ For TE or TM modes of propagation in bounded media, the phase velocity is
independent of frequency
is a linear function of frequency
is a non-linear function of frequency
can be frequency dependent or frequency independent on the source

⇒ In a radio receiver, the local oscillator is always tuned to a frequency higher than the incoming frequency to
facilitate tracking
allow permit adequate frequency coverage without switching
facilitate image frequency rejection
all of the above

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ In a CD the channel separation is
1 μm
1.6 μm
2.5μm
4 μm

⇒ Armstrong modulator generates
AM signals
FM signals
PM signals
both (b) and (c)

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ Consider the draw backs

Slope overload
Serration noise
Granular noise

Which of these draw backs does Delta modulation have?
1 and 2 only
2 and 3 only
1 and 3 only
1, 2, 3

⇒ The phase angle of lead circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ Transmitted voltage level is:
11
7.8
7.348 V
none of these

⇒ Consider the following statements as regards induction and dynamometer wattmeters

Dynamometer wattmeters can be used for dc only.
Induction wattmeter has higher torque and dynamometer wattmeter.
Induction wattmeter is less accurate, has more power consumption and more weight than dynamometer wattmeter.

Which of the above statements are correct?
1 only
1 and 2 only
2 and 3 only
1 and 3 only

⇒ QAM stands for
Quasi-Amplitude Modulation
Quadrature Angle Modulation
Quadrature Amplitude Modulation
None of the above

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒

Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ In a p type material the Fermi level is 0.3 eV above valence band. The concentration of acceptor atoms is increased. The new position of Fermi level is likely to be
0.5 eV above valence band
0.28 eV above valence band
0.1 eV above valence band
below the valence band

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ For a microprocessor system using IO-mapped IO the following statement is NOT true
memory space available is greater
not all data transfer instructions are available
IO and memory address spaces are distinct
IO address space is greater

⇒ The expression A ** B / C + D is equivalent to
AB / C + D
AB / C + D
AB / (C + D)
None of the above

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ The output impedance of a logic pulser is
low
high
may be Low or High
can't say

⇒ An open loop system has a forward path transfer function (42.25)/s(s + 6.5). The unit step response of the system starting from rest will have its maximum value at a time equal to
0 sec
0.56 sec
5.6 sec
infinity

⇒ A 14 pin NOT gate 1C has __________ NOT gates.
8
6
5
4

⇒ The pole-zero configuration of the given figure can be
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒ The action of backward wave oscillator is similar to that of
klystron amplifier
reflex klystron oscillator
TWT
magnetron

⇒ The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nea
0.43
0.3
0.23
0.17

⇒ If two networks are connected in series of individual Z parameter as Z_a and Z_b then equivalent Z is
[Z] = [Z_a] + [Z_b]
[Z] = [Z_a] [Z_b]
[Z] = [Z_a]/[Z_b]
[Z] = [Z_a] - [Z_b]

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)