Question is ⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Spontaneous magnetisation is characteristic of ferromagnetic materials.
TRUE
FALSE

⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
100 KHz
200 KHz
50 KHz
150 KHz

⇒

Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases.

Reason (R): Capacitance of any layer is inversely proportional to thickness.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Race condition occurs in
synchronous circuit
asynchronous circuit
combinational circuit
all the Digital circuit

⇒ The most commonly used bias in BJT amplifier circuits is
voltage divider bias
emitter bias
collector bias
collector feedback bias

⇒ We can know the arrangement of atom in a material by studying electron diffraction pattern.
TRUE
FALSE

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ The number of comparators of needed in a parallel conversion type 8 bit A to D converter is
8
16
255
256

⇒ Microwave signals transmitted towards the sky are
strongly absorbed by the ionosphere
strongly reflected by the ionosphere
transmitted through the ionosphere
unable to reach the ionosphere because of strong absorption in the lower atmosphere

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ The V_TH at terminals A and B is equa
0 V
5 V
-5 V
none

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ In the below figure the rms voltage across each half of secondary is 200 V. The peak inverse voltage across each of thyristor
200 V
2(200) V
2(400) V
800 V

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ Which of following digital modulation technique?
ASK
FSK
PSK
All

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

⇒ The knee voltages in silicon and germanium diodes respectively are
0.3 V and 0.7 V
0.7 V and 0.3 V
0.7 V each
0.3 V each

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
-0.6
-1
0.6
0

⇒ In a CE amplifier circuit the emitter by pass capacitor is remove. The ac output voltage
increases
remains the same
increases or decreases
decreases

⇒ Which of the following real variable names is not valid in Fortran?
BETA
ALPHA
A
AB * 2

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒ The design of wave filter is based on characteristic impedance which is
pure resistance
pure reactance
pure resistance in pass band and pure reactance in attenuation band
pure reactance in pass band and pure resistance in attenuation band

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ The number of cells in a 4 variable K map is
16
8
4
32

⇒ The relative permeability is taken as unity for which of the following?
Air
Cobalt
Vacuum
Bismuth

⇒ A higher value of Standing Wave Ratio indicates
least mismatch between line and load
greater mismatch between load and line
number of nodes is equal to the number of antinodes
none of the above

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N