Question is ⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal Is = cos 6t, the steady state voltage across Z is given in magnitude as u, Options are ⇒ (A) 0.6, (B) 0.84, (C) 7.2, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal Is = cos 6t, the steady state voltage across Z is given in magnitude as u, Options are ⇒ (A) 0.6, (B) 0.84, (C) 7.2, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
A.	0.6 [Wrong Answer]
B.	0.84 [Correct Answer]
C.	7.2 [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which is known as flash converter?
Weighted resistor D/A converter
Parallel A/D converter
Stair step A/D converter
Up-down counter type A/D converter

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:
9
11.11
data not sufficient
10

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒
Match the following:
List I List II
A. loop antenna 1. flat line
B. folded dipole 2. 300 W
C. SWR of 1 3. sharp broadside full
D. VHF band 4. 30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ An enhancement mode MOSFET is on when the gate voltage is
zero
positive
high
more threshold value

⇒ Radio broadcasting is a familiar example of
space multiplexing
time multiplexing
frequency multiplexing
none of the above

⇒ Which of the following is susceptible to race condition?
R-S latch
D latch
Both R - S and D latches
None of the above

⇒ In which frequency range is the noise figure in a transistor minimum
intermediate frequencies
low frequencies
high frequencies
very high frequencies

⇒ In a varistor, as the voltage increases beyond a certain value, its resistance
rapidly increases
rapidly decreases
becomes negative, i.e., varistor goes into negative resistance region
none of these

⇒ Modem warfare has changed from large scale clashes of armies to suppression of civilian populations. Chemical agents that do their work silently appear to be suited to such warfare; and regretfully, there exist, people in military establishments who think that chemical agents are useful tools for their cause, which of the following statements best sums up the meaning of the above passage:
Modem warfare has resulted in civil strife.
Chemical agents are useful in modem warfare.
Use of chemical agents in warfare would be undesirable.
People in military establishments like to use chemical agents in war.

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b can be in phase
phase angle between V_a and V_b would always be 90°

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒ In a loss line R_L < Z₀, then
Reflection coefficient is zero
Reflection coefficient is ∞
Reflection coefficient is negative
Reflection coefficient is positive

⇒ Which binary addition is incorrect?
1101.1 + 1011.1 = 11001.0
101101 + 1101101 + 1100011
0.0011 + 0.1110 + 1.0001
1100.001 + 1011.011 = 10111.100

⇒ The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
(t^2* e^-2t) U(t)
(t^* e^2t) U(t)
(te^-2t) U(t)
(te^2t) U(t)

⇒ Which of the following materials has the highest electrical conductivity?
Steel
Silver
Aluminium
Zinc

⇒ Which of the following is Doppler effect not used?
CW radar
FM radar
MTI system
Moving target plotting on PPI

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math