Question is ⇒ In figure, S is closed at t = 0. At t = t1, I = 1 A and di/dt = 1 A/s. Then the value of, Options are ⇒ (A) 1 H, (B) 2 H, (C) 3 H, (D) 4 H, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, S is closed at t = 0. At t = t1, I = 1 A and di/dt = 1 A/s. Then the value of, Options are ⇒ (A) 1 H, (B) 2 H, (C) 3 H, (D) 4 H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
A.	1 H [Wrong Answer]
B.	2 H [Correct Answer]
C.	3 H [Wrong Answer]
D.	4 H [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A step voltage E is applied to an R-L series circuit. At t = 0, the current in the circuit is
E/R
E/L
infinity
zero

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ In atomic physics, a state with l = 0 is called p state.
TRUE
FALSE

⇒ Program counter in a digital computer
counts the number of programs run in the machine
counts the number of times a subroutine
counts the number of time the loops are executed
points the memory address of the current or the next instruction

⇒ In an inverting amplifier using op-amp the current input to the inverting terminal
is equal to the current through feedback resistance
is less than the current through feedback resistance
is more than the current through feedback resistance
may be equal to, less or more than current through feedback resistance

⇒ The mobility of e^- for Ge and Si respectively is
1.66, 2.5
2.5, 1.66
2.7, 2.33
2.33, 2.7

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?
Measurement of unknown voltage
Measurement of resistance
Measurement of unknown current
Calibration of voltmeter

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ Which one of the following is an active component?
Diode (p-n)
Transistor as Amplifier
Transformer
Inductor

⇒ The characteristic equation for the next state (Q_n+1) of a J-K flip-flop is
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n

⇒ In an amplifier the stray capacitances assume impedance at low frequencies
TRUE
FALSE

⇒ When two conductors carry currents in the same direction the force is repulsive.
TRUE
FALSE

⇒ For telegraphy the most commonly used modulation system is
FSK
two tone modulation
PCM
single tone modulation

⇒ In a uniform plane wave E and H are related by
E/H = 1
E/H = ε/μ
E/H = μ/ε
none of the above

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ Which of these are universal gates?
Only NOR
Only NAND
Both NOR and NAND
NOR, NAND, OR

⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ A lens has a hyperfocal distance of 7.5 m. It is focused at 7.5 m. Then
all objects from 7.5 m to infinity will appear in focus
all objects from 3.75 m to infinity will appear in focus
all objects from 0 to 7.5 m will appear in focus
all objects from 0 to 3.75 m will appear in focus

⇒

Match the following:

	List I		List II
A.	Laser	1.	Emits monochromatic light of low intensity
B.	Solar cell	2.	Consumes electrical power due to incident light
C.	Photodiode	3.	Delivers power to a load
D.	LED	4.	Emits monochromatic light of high intensity

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2

⇒ The correct sequence of events to improve system stability is
insert derivative action, use negative feedback, reduce gain
reduce gain, use negative feedback, insert derivative action
reduce gain, insert derivative feedback, use negative feed back
use negative feedback, reduce gain, insert derivative action

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In the 2's complement Adder-Subtractor
sign magnitude numbers represent negative numbers
the sign magnitude numbers have "1" as leading bit
the sign magnitude numbers have '0' as leading bit
2's complement represents positive numbers

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ A colour television signal having bandwidth of 4.6 MHz is digitised using 10 bits sample. The digital bit rate used for its transmission with PCM would be __________ kilobits/second.
92000
920
23000
230

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec