Question is ⇒ In a photo transistor the photocurrent is, Options are ⇒ (A) emitter base junction, (B) collector base junction, (C) collector, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ In a photo transistor the photocurrent is, Options are ⇒ (A) emitter base junction, (B) collector base junction, (C) collector, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a photo transistor the photocurrent is
A.	emitter base junction [Wrong Answer]
B.	collector base junction [Correct Answer]
C.	collector [Wrong Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If carrier modulated by a digital bit stream had one of the possible phases of 0°, 90°, 180°, 270°, then the modulation is called.
BPSK
QPSK
QAM
MSK

⇒ For measuring inductance with high Q, we should use
Maxwell's bridge
Maxwell Wien bridge
Hay's bridge
Either (a) or (b)

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ In a bipolar transistor
recombination in base regions of both n-p-n and p-n-p transistor is low
recombination in base regions of both n-p-n and p-n-p transistors is high
recombination in base region of n-p-n transistor is low but that in p-n-p transistor is high
recombination in base region of p-n-p transistor is low but that in n-p-n transistor is high

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE

⇒ In communication receivers the fidelity is provided by
audio stage
detector range
mixer stage
all of the above

⇒ Find the value of i_x if each resistance is of 3 Ω and each battery is of
1.1428 V
1.432 A
0.2892 A
O A

⇒ The modulation index of an AM wave is changed from 0 to 1. The transmitted power is
unchanged
halved
increased by 50%
quadrupled

⇒ In a satellite system circular polarization is to be obtained. The antenna used is
parabolic
horn
log periodic
helical

⇒ Which camera tube has gamma of almost unity?
Vidicon
Plumbicon
New vicon
Saticon

⇒ In a N-P-N transistor of the emitter junction is reverse biased and collector junction is also reversed biased, the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒

Assertion (A): In hot wire instrument the material of hot wire in generally platinum iridium.

Reason (R): A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ Which of the following functions would have only odd powers of x in its Taylor series expansion about the point x = 0?
sin (x³)
sin (x²)
cos (x³)
cos (x²)

⇒ Given that the band gap of cadmium sulphide is 2.5 eV, the maximum photon wavelength, for e^--hole pair generation will be
5400 mm
540 mm
5400 Å
540 Å

⇒ The 2732 is 4096 x 8 EPROM. How many address lines does it have?
12
24
50
100

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ Which of the following are difficult to be fabricated in a monolithic IC?
Inductors
Large capacitors
Small capacitors
Both (a) and (b)

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒

Match the following:

	List I		List II
A.	D Layer	1.	110 km
B.	E layer	2.	10 km
C.	F layer	3.	60 km
D.	Troposphere	4.	350 km

A-3, B-1, C-4, D-2
A-2, B-1, C-4, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-1, D-2

⇒ The torque in induction wattmeters due to
capacitive current
electrostatic effect
hall effect
eddy currents

⇒ In a perfect conductor the resistor noise is
maximum
zero
very high
almost infinite

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒ Consider the following statements:

Strictly speaking C supports 1-dimensional arrays only.
An array element may be an array by itself.
Array elements need not occupy contiguous memory locations.

Which of the above statements is/are correct?
1 only
2 only
1 and 2
2 and 3

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The address to which a software or hardware restart branches is known as
Vector location
SID
SOD
TRAP