Question is ⇒ If a common emitter amplifier with an emitter resistance R<sub>C</sub> has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be, Options are ⇒ (A) 50 kΩ, (B) 0.98 kΩ, (C) 50 Ω, (D) 0.98 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ If a common emitter amplifier with an emitter resistance R<sub>C</sub> has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be, Options are ⇒ (A) 50 kΩ, (B) 0.98 kΩ, (C) 50 Ω, (D) 0.98 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
A.	50 kΩ [Wrong Answer]
B.	0.98 kΩ [Correct Answer]
C.	50 Ω [Wrong Answer]
D.	0.98 Ω [Wrong Answer]
View Answer 1 -6 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The resistivity of a semiconductor
increases as the temperature increases
decreases as the temperature increases
remains constant even when temperature varies
none of the above

⇒ An amplifier has to amplify pulses of 1 H-s duration. The minimum bandwidth of amplifier must be
10 kHz
10 MHz
1 kHz
1 MHz

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ The tree selected for the formation of state equations contains
all voltage sources
all capacitors
all inductors and current sources
all voltage sources and maximum number of capacitors

⇒ The main reason why Ni-Zn ferrites are used for audio and T.V. transformers is that
they have large saturation magnetization
they are easy to fabricate by rolling
they are totally free from pores and voids
they have a high electrical resistivity

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ The voltage of single phase supply to residential consumers in India is
400 V
230 V
2.2 kV
11 kV

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
sin ω₁t + sin ω₂t

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ Indicate the false statement: If SWR on a transmission line is infinite, the line is terminated in
open circuit
short circuit
pure reactance
complex impedance

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ Macroscopic quantities of a given material
are absolutely constant
are a function of temperature
are a function of temperature, pressure field
none of the above

⇒ If operator 'a' = 1 ∠120° then (1 + a²) =
3
3 ∠30°
3 ∠ - 30°
3 ∠60°

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒ MUF is highest in periods of greatest sunspot activity.
TRUE
FALSE

⇒ The organisatioion of Intel memory chip 127256 is
32 K x 8
16 K x 8
32 K x 4
16 K x 4

⇒ If temperature is increased, the temperature coefficient of a metal
increases
decreases
may increase or decrease
remains constant

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒

Match the following:

	List I (Processor in C)		List II (Output)
A.	Preprocessor	1.	Source code file
B.	Compiler	2.	Executable code in machine language
C.	Linker	3.	Relocatable object code

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ Which one is time invariant system?
y[n] = x[2n]
y[n] = x[n] x[n - 1]
y[n] = x[n/2]
all

⇒ The highest modulation frequencies typically used in FM broadcast is
5 kHz
10 kHz
15 kHz
25 kHz

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ A circular sphere mile is the area of cross-section of a wire
having a diameter equal to 1 miles
having a radius equal to 1 miles
having a circumference equal to 1 miles
none of the above