Question is ⇒ For the system in the given fi, Options are ⇒ (A) yk = uk + 0.5 yk - 2, (B) yk = uk + 0.5 uk - 2, (C) yk = uk - 0.5 yk - 2, (D) yk = uk - 0.5 uk - 2, (E) , Leave your comments or Download question paper.

Question is ⇒ For the system in the given fi, Options are ⇒ (A) yk = uk + 0.5 yk - 2, (B) yk = uk + 0.5 uk - 2, (C) yk = uk - 0.5 yk - 2, (D) yk = uk - 0.5 uk - 2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the system in the given fi
A.	y_k = u_k + 0.5 y_{k - 2} [Correct Answer]
B.	y_k = u_k + 0.5 u_{k - 2} [Wrong Answer]
C.	y_k = u_k - 0.5 y_{k - 2} [Wrong Answer]
D.	y_k = u_k - 0.5 u_{k - 2} [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE

⇒ Unit step is a
energy signal
power signal
neither energy nor power signal
none

⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m

⇒ Figure shows the terminals of a transistor in plastic package TO 18. T
terminals 1, 2, 3 are emitter, collector, base respectively
terminals 1, 2, 3 are emitter, base, collector respectively
terminals 1, 2, 3 are base, emitter collector, respectively
terminals 1, 2, 3 are collector, emitter, base respectively

⇒ A directional microphone gives an output of 0.5 mV whereas an omnidirectional one gives an output of 0.5 μV in the same position for the same sound pressure. The directivity of the directional microphone is
120 dB
90 dB
60 dB
30 dB

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ When a plane wave travelling in free space is incident normally on a medium having ε_r = 4.0, then fraction of power transmitted into the medium is given by
42956
42737
42738
42861

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ Which of the following material has nearly zero temperature-coefficient of resistance?
Carbon
Porcelain
Copper
Manganin

⇒ A 2 bit binary multiplier can be implemented using
2 inputs ANDs only
2 I/P XOR and 4 I/P AND gate only
two 2 inputs NORs and One XNOR gate
XOR gates and shift registers

⇒ The changes in ambient temperature affect the open loop gain of amplifier.
TRUE
FALSE

⇒ A thyristor circuit is feeding an R-L load. The turn on time can be reduced by
decreasing R
decreasing L
increasing L
decreasing R and L together

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line

⇒ In the saturation region of CE output characteristics of n-p-n transistor, V_CE is about
0.5 V
15 V
- 0.5 V
- 15 V

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ In op-amp integrating amplifier the input is feed to
inverting input
non-inverting input
both inverting and non-inverting input
either inverting or non-inverting input

⇒ Surface leakage current is a part of
reverse current
forward current
reverse breakdown
forward breakdown

⇒ Which of the following circuit cannot be used to demodulate SSB?
Phase discriminator
Produce detector
Balanced modulator
Beat frequency oscillator

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is
40 mA
20 mA
10 mA
5 mA

⇒ What is the maximum output voltage from the 741 op-amp?
Zero
Approximately 1 V
Approximately 3 V
Approximately 5 V

⇒ Consider the transmission line of length 37.5 cm, which is terminated into zero resistance. This line is being exited by a source of 1 GHz which has an internal impedance of 50 Ω. What is the input impedance of the line as seen by the source?
50 Ω
Zero Ω
100 Ω
Infinite Ω

⇒ Consider the following features of an instrument

suitable for both ac and dc
free from hysteresis and eddy current errors
No waveform and frequency errors
it is essentially a voltmeter

This instrument is
moving iron
moving coil
electrostatic
dynamometer

⇒ The boolean expression for shaded area in the given figur
AB + AC
ABC + ABC
ABC + ABC
None of these

⇒ In selecting a satellite system, the First determining factor is its
EIRP
antenna size
coverage a sea
antenna gain

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal