Question is ⇒ Which of the following is very useful as multiband HF receiving antenna?, Options are ⇒ (A) Square loop, (B) Conical horn, (C) Folded dipole, (D) Log-periodic, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is very useful as multiband HF receiving antenna?, Options are ⇒ (A) Square loop, (B) Conical horn, (C) Folded dipole, (D) Log-periodic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is very useful as multiband HF receiving antenna?
A.	Square loop [Wrong Answer]
B.	Conical horn [Wrong Answer]
C.	Folded dipole [Wrong Answer]
D.	Log-periodic [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The process of deliberately adding impurity to a semi-conductor material is called
impurification
pollution
deionisation
doping

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ For an insulating material, dielectric strength and dielectric losses should be
high and high
low and high
high and low
low and low

⇒ The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of t
curves 1, 2, 3 are for type 0, 1, 2 systems respectively
curves 1, 2, 3 are for type 2, 1, 0 systems respectively
curves 1, 2, 3 are for type 1, 0, 2 systems respectively
curves 1, 2, 3 are for type 1, 2, 0 systems respectively

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
y + 0.57x = 9.7558
y - 0.57x = 9.758
033y + x = 6.335
0.33y - x = 6.335

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ In FM, as the modulating frequency decreases and the modulating voltage amplitude
increases, the modulation index increases
decrease, the modulation index increases
remains constant, the modulation index increases
remains constant, the modulation index decreases

⇒ The selectivity of most receivers is determined largely by
sensitivity
characteristics of IF section
antenna direction
all of the above

⇒ Which converter is used in HVDC transmission?
3 pulse
6 pulse
12 pulse
24 pulse

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ The more negative gate voltage, the conductive channel becomes
narrower
wider
thicker
linear

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about
20 μV
5μV
14.14 μV
10 μV

⇒ A single phase semiconverter is supplying RLE load and has a freewheeling diode across the load. The firing angle is a. The freewheeling diode conducts for
a° in each half cycle
(p - a)° in each cycle
a° in one full cycle
(p + a)° in each half cycle

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current through
0.166666666666667
2.5 A
3.1 A
0

⇒ In a resistance loaded, RC coupled amplifier the d.c. component is blocked by
Transistor
C_C
R_B
R_C

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ When a transistor is to be at a temperature above 25°C
smaller heat sink be provided
maximum power rating be derated
biasing circuit must be strengthened
earth connections must be connected through a resistor

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 K ohm is also in series with the diode. The current is
7 mA
6.3 mA
0.7 mA
0

⇒ A 100 + j 100 Ω load is to be matched to a line with Z₀ = 300 Ω to give SWR = 1. The reactance of stub is
j 200 Ω
-j 200 Ω
j 100 Ω
-j 100 Ω

⇒ Poynting vector is associated with which of the following?
Power flow in electromagnetic
Flux in magnetic field
Charge in electrostatic field
Current in electrostatic field

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ The selectivity of a radio receiver is
its ability to reject adjacent unwanted signals
its ability to amplify weak signals
the frequency at which it gives maximum amplification to signal.
its ability to suppress noise.

⇒ LCD uses
nematic crystals
sematic crystals
cholesteric crystals
twisted nematic crystal

⇒ In figure, V_{AB6 V
10 V
25 V
40 V}