Question is ⇒ In the analogy between electric and magnetic circuits, flux is analogous to, Options are ⇒ (A) current, (B) voltage, (C) rate of charge of current, (D) rate of charge of voltage, (E) , Leave your comments or Download question paper.

Question is ⇒ In the analogy between electric and magnetic circuits, flux is analogous to, Options are ⇒ (A) current, (B) voltage, (C) rate of charge of current, (D) rate of charge of voltage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the analogy between electric and magnetic circuits, flux is analogous to
A.	current [Correct Answer]
B.	voltage [Wrong Answer]
C.	rate of charge of current [Wrong Answer]
D.	rate of charge of voltage [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The no. of FF required and the maximum decimal no. of a MOD-12 counter is
12, 12
4, 11
3, 6
4, 10

⇒ The maximum number of characters for variable names in C is
4
8
12
16

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ In a zener diode
forward voltage rating is high
negative resistance characteristics exists
sharp breakdown occurs at low reverse voltage
none of the above

⇒ In a self bias circuit for CE amplifier, an increase in emitter resistance R_E results in
increase in emitter voltage
decrease in emitter voltage
increase in emitter current
decrease in emitter current

⇒ In a microwave coaxial cable the inner conductor radius is a and inner radius of outside conductor is b. For TE₁₁ mode the cut off wavelength is about
a + b
p(a + b)
pa
pb

⇒ Each cell of static RAM contains
4 MOS transistors
4 MOS transistors and 1 capacitor
2 MOS transistors
4 MOS transistors and 2 capacitors

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The sinusoidally time varying vector fi
elliptically polarized
circularly polarized
linearly polarized
unpolarized

⇒ For the K map of the given figure the simplified Boolean expressio
AC + A B
A BC + A B C + A B C + AB C
AC + A B + AC
A C + A B + AB

⇒ When diodes are connected in series to increase voltage rating the peak inverse voltage per junction
should not exceed half the breakdown voltage
should not exceed the breakdown voltage
should not exceed one third the breakdown voltage
may be equal to or less than breakdown voltage

⇒ In a 4 bit D/A converter, the offset error is the output voltage when input digital voltage is
1111
0
either 1111 or 0000
none of the above

⇒ In the op-amp circuit of figure, V_{03 V₁ - 4 V₂
-3 V₁ + 4 V₂
3(V₁ - V₂)
-3(V₁ - V₂)}

⇒

Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In cellphone communication base antennas are connected to other base antennas in
line of sight communication
ionospheric propagation
ground wave propagation
medium wave propagation

⇒ When a single phase dual converter is operating in circulating current mode
both converters are working as rectifiers simultaneously
one converter is always working as rectifier and the other as inverter
only one converter is working at one time
both converters are either working as rectifiers or as inverters simultaneously

⇒ In a transmission line terminated with a load equal to the characteristic impedance, the reflection coefficient is
0
1
-1
Infinity

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ When phase-lag compensation is used in a system, then gain cross over frequency, bandwidth and undamped frequency are respectively
Increased, Increased, Increased
Increased, Increased, Decreased
Increased, Decreased, Decreased
Decreased, Decreased, Decreased

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ Decimal 17 in octal system is represented by
888
111
21
27

⇒ Which one is not correct for folded dipole antenna?
High I/P impedance
Low I/P impedance
High bandwidth
Used as reactance compensation network

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ For an ideal 3000 Hz channel, Nyquist rate is
3000 bps
6000 bps
9000 bps
12000 bps

⇒ Calculate wave impedance for TE mode
(377)Ω
226 Ω
∞
629 Ω

⇒ In one time constant, the current in a circuit reaches __________ percent of its final value.
10
37
63
85

⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be
6
12
720
1040

⇒ In figure, the transmission parameters are A = C = 1, B = 2 and D = 3. Then Z_{in12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ Thermal noise has a power spectral density which is quite uniform upto frequencies in the order of
100 Hz
10⁶ Hz
10⁹ Hz
10¹³ Hz