Question is ⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is, Options are ⇒ (A) 21 kHz, (B) 22 kHz, (C) 42 kHz, (D) 44 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is, Options are ⇒ (A) 21 kHz, (B) 22 kHz, (C) 42 kHz, (D) 44 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
A.	21 kHz [Wrong Answer]
B.	22 kHz [Wrong Answer]
C.	42 kHz [Wrong Answer]
D.	44 kHz [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ In the given figure the input is x(t) = A sin ωt. The steady state output y(tA sin (ωt + φ) where φ = tan^-1 |G(jω)|
|G(jω)| A sin [ωt + ∠G(jω)]
|G(jω)| A sin [2ωt + ∠G(jω)]
A G(jω) sin [ωt + ∠G(jω)]

⇒ Binary 1000 multiplied by binary 1000 gives
10000
100000
1000000
10000000

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?
linear for any value of b
linear if b > 0
linear if b < 0
non-linear

⇒ Velocity of the wave when it passes from air into sphere
decreases
increases
same
no change

⇒ Which of the following form of angle modulation in this? If e = 10 sin(10⁸ t + 3 sin 10⁴ t)
AM
FM
AM or FM
AM or PCM

⇒ If a signal f(t/2) has energy is E/n then energy of the signal f(nt) is equal to __________ (n is constant)
E/2n²
2E/n²
E/n²
2En²

⇒ Which of the following statements is/are true for a good conductor of electricity?
Its conductivity decreases with increasing temperature.
Number of free electrons is around 10²⁸ m^-3.
Its conductivity decreases with addition of impurities.
It is a good conductor of heat also.

1, 2, 3 and 4
1 only
2 and 3 only
3 and 4 only

⇒ The number of essential prime implicant for the logic express
3
5
4
6

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ For an illumination control circuit it is advisable to use a matched TRIAC-DIAC pair.
TRUE
FALSE

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ A Hartley oscillator uses
a tapped capacitor
a tapped inductor
a tapped inductor for inductive feedback
none of the above

⇒ The most commonly used system of modulating for telegraphy is
single tone modulation
on-off keying
frequency shift keying
pulse code modulation

⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be
± 0.7%
± 0.9%
± 1.2%
± 0.3%

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒ If zeros at infinity are included in the count, the number of zeros of G(s) H(s) is
equal to number of poles
one more than the number of poles
one less than the number of poles
none of the above

⇒ Which of the following instruments has non-linear scale?
Moving coil instrument
Moving iron instrument
Electrostatic instrument
Rectifier instrument
Select the answer as per following codes
2 only
2 and 3 only
2, 3 and 1
1, 2, 3 and 4

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ The magnitude response of a normalised Butterworth low pass filter is
linear starting with value of unity at zero frequency and 0.707 at cut off frequency
non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency
linear upto cut off frequency and nonlinear thereafter
nonlinear upto cut off frequency and linear thereafter

⇒ Consider the following:
Distortion
Gain
Bias stabilization
Sensitivity
Frequency response
Which of these properties of the power amplifier one should concentrate upon while designing a good power amplifier circuit?
1, 2 and 3
1, 3 and 5
2, 3 and 4
4 and 5

⇒ Watthour meter is an integrating instrument
TRUE
FALSE

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math