Question is ⇒ How can the bandwidth of a control system be increased?, Options are ⇒ (A) By the use of phase lead network, (B) By the use of phase lag network, (C) By the use of both phase-lag and phase-lead network, (D) By the use of cascaded amplifiers in the system, (E) , Leave your comments or Download question paper.

Question is ⇒ How can the bandwidth of a control system be increased?, Options are ⇒ (A) By the use of phase lead network, (B) By the use of phase lag network, (C) By the use of both phase-lag and phase-lead network, (D) By the use of cascaded amplifiers in the system, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	How can the bandwidth of a control system be increased?
A.	By the use of phase lead network [Correct Answer]
B.	By the use of phase lag network [Wrong Answer]
C.	By the use of both phase-lag and phase-lead network [Wrong Answer]
D.	By the use of cascaded amplifiers in the system [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A narrow band noise show
AM only
AM and FM
FM
PCM

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs

⇒ In case of frequency modulation, modulating voltage remains constant if the modulating frequency is lowered, then
amplitude of distant sidebands decreases
amplitude of distant sidebands increases
amplitude of distant sidebands remains constant
amplitude of distant sidebands first increases, then decreases

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ Consider the following statements relating to synchros

Rotor of control transformer is either disc shaped or umbrella shaped
Rotor of transmitter has low magnetic reluctance
Transmitter and control transformer pair act as error detector

Out of above the correct statements are
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ A UJT exhibits negative resistance characteristics when
Current is less than valley current
Current is less than peak current
Current is more than peak current but less than valley current
None of the above

⇒ The impedance of a coil above self-resonant frequency is
inductive
capacitive
resistive
none

⇒ The force required to initiate motion between two contacting surfaces is called
coulomb friction
viscous friction
static friction
none of the above

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ Two wires A and B have the same cross-section area and are made of the same material. R_A = 600 Ω and R_B = 100 Ω. The number of times A is longer than B is
6
2
4
5

⇒ What happens when a paramagnetic material is heated above Curie temperature?
It becomes diamagnetic
It becomes nonmagnetic
It becomes ferromagnetic
It becomes anti-ferromagnetic

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ Which of the following measurements can be done using a counter?

Pulse duration
Interval between two pulses
Amplitude of the pulse
Rise time of a pulse

Select the correct answer from the codes given below:
1 and 2
2 and 3
1 and 4
2 and 4

⇒ Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is
0.85
0.67
0.19
0.08

⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V

⇒ System
causal
stable
non causal
anticausal

⇒ After reflection from a plane conducting surface, the apparent velocity of electromagnetic wave becomes greater than the velocity of light in free space is called
conventional velocity
phase velocity
propagation velocity
group velocity

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ When we use RRC instruction once in 8085, the number is
multiplied by 2
divided by 2
multiplied by 4
divided by 4

⇒ During day time ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
D and E layers

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the circuit of figure for sinusoidal input the waveform of the output will be as show
figure A
figure B
figure C
figure D