Question is ⇒ For an op-amp source follower circuit, Options are ⇒ (A) input and output voltages have same magnitude, (B) output and input voltages are in phase, (C) output and input voltages are in phase but have different magnitudes, (D) output and input voltages have same magnitude and are in phase, (E) , Leave your comments or Download question paper.

Question is ⇒ For an op-amp source follower circuit, Options are ⇒ (A) input and output voltages have same magnitude, (B) output and input voltages are in phase, (C) output and input voltages are in phase but have different magnitudes, (D) output and input voltages have same magnitude and are in phase, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an op-amp source follower circuit
A.	input and output voltages have same magnitude [Wrong Answer]
B.	output and input voltages are in phase [Wrong Answer]
C.	output and input voltages are in phase but have different magnitudes [Correct Answer]
D.	output and input voltages have same magnitude and are in phase [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Let the initial contents of ACC and CY in 8085 be

CY = 1
ACC = 10000001

After the instruction RAL is executed twice the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000111
1 and 00000111
0 and 00000011

⇒ Which of the following devices uses a helix?
Klystron amplifier
Klystron oscillator
TWT
Both (a) and (b)

⇒ Telecine equipment in a TV studio consists of
projector telecine
flying spot telecine
digital CCD telecine
none of the above

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
6 dB and 180°
3 dB and 180°
6 dB and 90°
3 dB and 90°

⇒

Assertion (A): A cycloconverter may be line commutated or forced commutated

Reason (R): A step up cycloconverter requires forced commutation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ The Clapp oscillator shown in figure will operat
4.6 kHz
46 kHz
460 kHz
4600 kHz

⇒ Figure represen
Varactor
LED
Zener diode
Temperature dependent diode

⇒ Volt is equivalent to
joule/coulomb
joule/watt
joule/ampere
joule/volt

⇒ An antenna is synonymous to a
generator
transformer
regulator
reflector

⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE

⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
0
101
1010
1111

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒ Square law modulators utilise
linear range of V-I characteristics of a diode
linear range of V-I characteristics of a triode
non-linear region of V-I dynamic characteristics of a diode
non-linear region of V-I dynamic characteristics of a triode

⇒ If D is mouth diameter of a paraboloid reflector, its directivity is proportional to
D
D²
D
D³

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒ In figure, the current I_{410 ∠0
5 ∠90°
5 ∠270°
10 ∠90°}

⇒ Radiation intensity does not depend upon
the antenna direction
antenna width
both (a) and (b)
none of the above

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ In a varistor the v-i graph is linear.
TRUE
FALSE

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ In terms of ABCD parameters, the image parameter Z₁₁ is equal to
AC/BD
BD/AC
AB/CD
AD/BC