Question is ⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is, Options are ⇒ (A) E/R, (B) E/LC, (C) zero, (D) infinity, (E) , Leave your comments or Download question paper.

Question is ⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is, Options are ⇒ (A) E/R, (B) E/LC, (C) zero, (D) infinity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
A.	E/R [Wrong Answer]
B.	E/LC [Wrong Answer]
C.	zero [Correct Answer]
D.	infinity [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When phase-lag compensation is used in a system, then gain cross over frequency, bandwidth and undamped frequency are respectively
Increased, Increased, Increased
Increased, Increased, Decreased
Increased, Decreased, Decreased
Decreased, Decreased, Decreased

⇒ The signals in 8086 are in maximum mode when
MN / MX pin is tied to V_cc
MN / MX Pin is grounded
MN / Mx pin is left open
none of the above

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ Consider the following statements about instrument landing system of aircraft

It ensures correct landing under conditions of low visibility.
It consists of runaway localizer, glide path equipment and marker beacons.
It is basically a blind landing system.

Which of above statements are correct?
All
1 and 2 only
1 and 3 only
2 only

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ A TV. transmitting aerial is fixed on top of a 150 metre tower located on a mountain 1200 m height. The range of transmitter is
51 km
152 km
152 m
51 m

⇒ Which of the following could be the maximum current rating of junction diode by 126?
0.0416666666666667
0.416666666666667
20 A
100 A

⇒ The effect of earth's magnetic field on radiowaves is minimum when
the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
both (b) and (c)

⇒ In a practical oscillator, the magnitude of loop gain Aβ is kept slightly larger than unity and the amplitude of oscillations is limited by
the ratio of A to β
the on set of non-linearity of amplifying device
the linearity of amplifying device
all of the above

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz

⇒ How many flag are there in 8085 microprocessor?
4
5
6
8

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111

⇒ In a computer the data transfer between hard disk and CPU is nearly the same as that between diskette and CPU.
TRUE
FALSE

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ When tracing through a resistance we always get a voltage drop.
TRUE
FALSE

⇒ The resistivity of intrinsic semiconductor material is about
10⁵ ohm-m
10³ ohm-m
100 ohm-m
1 ohm-m

⇒ In a 3 input NAND gate, the number of states in which output is 1 equals
8
1
6
5

⇒

Assertion (A): A multiplexer can be used for data routing.

Reason (R): A multiplexer has one input and many outputs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ Consider the following symbols

Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )

Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
immediate

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ Two similar coupled coils are connected in series. The total inductance in series aiding connection is 100 mH. If currents is 3 A, the energy stored in magnetic field is
0.9 J
0.45 J
0.225 J
1.8 J

⇒ A CW transmitter radiates
modulated RF carrier
unmodulated RF carrier
both (a) and (b)
none of the above

⇒ PROM is
Permanent Read Only Memory
Polarized Read Only Memory
Positive Read Only Memory
Programmable Read Only Memory

⇒ DMA stands for direct memory access.
TRUE
FALSE

⇒

Assertion (A): Field emission is substantially independent of temperature.

Reason (R): When a high electric field is created at metal surface field emission may occur.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true