Question is ⇒ In a series RLC circuit, the current at resonance is I0 the total energy stored in the circuit at resonance is, Options are ⇒ (A) LI02, (B) 2 LI02, (C) 2 LI02, (D) 0.5 LI2, (E) , Leave your comments or Download question paper.

Question is ⇒ In a series RLC circuit, the current at resonance is I0 the total energy stored in the circuit at resonance is, Options are ⇒ (A) LI02, (B) 2 LI02, (C) 2 LI02, (D) 0.5 LI2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a series RLC circuit, the current at resonance is I₀ the total energy stored in the circuit at resonance is
A.	LI₀² [Correct Answer]
B.	2 LI₀² [Wrong Answer]
C.	2 LI₀² [Wrong Answer]
D.	0.5 LI² [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is true?
The poisson distribution is limiting case of binomial distribution.
In symmetrical distribution, the mean, median and mode coincide.
Regression is the estimation or production of unknown values of one variables from known values of another variable.
All are true.

⇒ Which of the following is the poorest conductor of electricity?
Copper
Aluminium
Manganin
Nichrome

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ To couple a coaxial line to a parallel to wire line it is best to use a
slotted line
balun
directional coupler
quarter wave transformer

⇒ A dielectric is subjected to alternating field. The dielectric losses are potential to
real part of dielectric constant
imaginary part of dielectric constant
both real and imaginary parts of dielectric constant
either real or imaginary part of dielectric constant

⇒ The dynamic characteristics of capacitive transducer are similar to those of
LP filter
HP filter
notch filter
band stop filter

⇒ It is desired to clean up ragged looking pulsed that have been distorted during transmission from one place to another, which of the following device will be appropriate?
Multiplexer
D/A converter
JK flip-flop
Schmitt trigger

⇒ Serial input data of 8085 can be loaded into bit-7 of the accumulator by
executing a RIM instruction
executing RSTI
using TRAP
none of the above

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ Which of the following statements is not correct regarding modes of electromagnetic energy transmission?
In TE mode the direction of electric field is always and everywhere transverse to the direction of propagation
In TM mode the magnetic field pattern is always and everywhere transverse to the direction of propagation
The subscripts is TE and TM designations denote the number of half sine wave variations of the field components in x and y directions respectively.
TM₁₁ is called the dominant mode.

⇒ A sample of N type semiconductor has electron density of 6.25 x 10⁸/cm² at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 kΩ is also connected in series. If the diode is forward biased, the current in the circuit is
7 mA
6.3 mA
0.7 mA
0

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is
125
250
1125
3125

⇒ The DTFT of x(n) = δ(n) will be
1
0
∞
not defined

⇒ In sound recording the degree of pre-emphasis is about 6 dB/ octave.
TRUE
FALSE

⇒ The attenuation in waveguides near the cut off frequency is
very low
very high
medium
zero

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ Surface impedance at high frequencies is a consideration for
ferrites
semiconductors
good conductors
dielectrics

⇒ In 8085, TRAP is
always maskable
cannot interrupt a service subroutine
used for catastrophic events like temporary power failure
lowest priority interrupt

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ A rare gas has N atoms per m³. If electronic polarizability of single atom of this gas is a_e, then
∈_r = Na_e
∈₀∈_r = Na_e
∈₀(∈_r - 1) = Na_e
∈₀(∈_r - 2) = Na_e

⇒ The standard intermediate frequency for FM ratio is
10.7 MHz
4.5 MHz
75 kHz
455 kHz

⇒ Which of the following statements is incorrect?
Ideal voltage source is one whose internal resistance is zero
Ideal voltage source is one whose internal conductance is zero
Ideal voltage source is one whose generated voltage is equal to the available terminal voltage
Ideal current source is one whose internal conductance is zero

⇒ For formation of state equations, resistance of the circuit
should be in tree
should be in cotree
may be in tree or cotree
none of the above

⇒ In the switching circuit, switches A, B have value 0 for OFF, 1 for ON and the output Y has 0 volts for 1 volts, then the expression for
AB
A + B
A + B
AB

⇒ For an insulating material, dielectric strength and dielectric losses should be
high and high
low and high
high and low
low and low

⇒ For a second order system ω_n is natural frequency, ω_d is frequency of damped oscillations and ζ is damping factor. Then
ω_d = ω_n ξ
ω_d = ω_n (1 - ξ)²
ω_d = ω_n (1 - ξ)^0.5
ω_d = ω_n (1 - ξ²)^0.5

⇒ For a series resonant circuit at low frequency circuit impedance is __________ and at high frequency circuit impedance is _______
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive

⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates