Question is ⇒ The circuit of figure is generally employed, Options are ⇒ (A) bridge, (B) low-pass filter, (C) peaking network, (D) high-pass filter, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit of figure is generally employed, Options are ⇒ (A) bridge, (B) low-pass filter, (C) peaking network, (D) high-pass filter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit of figure is generally employed
A.	bridge [Wrong Answer]
B.	low-pass filter [Correct Answer]
C.	peaking network [Wrong Answer]
D.	high-pass filter [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above

⇒ For a NOR SR latch the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 0, R = 0
S = 1, R = 0

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A push pull amplifier is a
power amplifier
voltage amplifier
current amplifier
both power and current amplifier

⇒

Assertion (A): The output voltage of an inverter can be controlled by PWM technique

Reason (R): In a current source inverter the input current is constant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For measuring a very high resistance we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (a) or (c)

⇒ In the output of a DM speech encoder, the consecutive pulses are of opposite polarity during time interval t₁ < t < t₂. This indicates that during this interval
the input to the modulator is essentially constant
the modulator is going through slope overload
the accumulator is in saturation
the speech signal is being sampled at the Nyquist rate

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In which configuration does output ac voltage appear between emitter and ground?
CE
CB
CC
Both CE and CB

⇒ In a oscillator, a sine wave generator starts at t = 0. It consist of
Pure sine wave
Pure cosine wave
Unity for t > 0
2∪(t) - 1

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ A series circuit has R = 5 Ω and C = 10 μF. At t = 0 it is switched on to a 10 V dc battery. The maximum current in the circuit is
0.0833333333333333
0.0416666666666667
10⁶A
10 μA

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ Which of the following is not an electromagnetic device?
Hall transducer
Transformer
Speedometer
Eddy current damping device

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ The ASCII code is
5-bit code
7-bit code
9-bit code
11-bit code

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ The resolution of an n bit DAC with a maximum input of 5 V is 5 mV. The value of n is
8
9
10
11

⇒ The function shown in the given Figure can be writte
sum of two sinusoidal functions
sum of two sinusoidal functions one originating at t = 0 and the other at t = 1
difference of two sinusoidal functions one originating at t = 0 and the other at t = 1
none of the above

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
EI only
SIM only
EI and SIM both
None

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ The eigen values of a skew symmetric matrix are
always zero
always pure imaginary
either zero or pure imaginary
always real

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following line 15
line 25
line 35
any of the lines 15 or 25, 35