Question is ⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will, Options are ⇒ (A) remain same, (B) become half, (C) become doubled, (D) become four times, (E) , Leave your comments or Download question paper.

Question is ⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will, Options are ⇒ (A) remain same, (B) become half, (C) become doubled, (D) become four times, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
A.	remain same [Wrong Answer]
B.	become half [Correct Answer]
C.	become doubled [Wrong Answer]
D.	become four times [Wrong Answer]
View Answer 3 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒

Assertion (A): CMOS devices have very high speed.

Reason (R): CMOS devices have very small physical size and simple geometry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ The number of bits in ASCII is
12
10
9
7

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Which of the following modes of transmission will not be supported by a rectangular waveguide?
TE₁₅
TE₁₂
TM₁₁
TM₁₀

⇒ A uniform plane EM wave incident normally on a plane surface of a dielectric material is reflected with a VSWR of 3. What percentage of incident power that is reflected?
0.1
0.25
0.5
0.75

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis
figure A
figure B
figure C
none

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ The impedance 3.2 - j 12 in polar form is given as
6.4 ∠ - 75°
8.4 ∠ - 75°
10.4 ∠ - 75°
12.4 ∠ - 75°

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
50 A
25 A
less than 50 A but more than 25 A
less than 25 A

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above

⇒ Bandwidth for practical PCM system is (where n is no. of channels, N length of PCM codes)
2n N f_m Hz
4n f_m Hz
2n f_m
(N + 1)f_m

⇒ In a TV receiver antenna the length of reflector rod
is the same as that of dipole
is less than that of dipole
is more than that of dipole
may be equal, more or less than that of dipole

⇒ The force required to initiate motion between two contacting surfaces is called
coulomb friction
viscous friction
static friction
none of the above

⇒

Assertion (A): A high junction temperature may destroy a diode.

Reason (R): As temperature increases the reverse saturation current increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode?
The duration of output waveform is less than 180°
Output voltage is less than input voltage
Output voltage is more than input voltage
Both (a) and (b)

⇒ Choose the correct option

Transit period is the time between two steady state
Transient Response is the response due to internal energy stored in circuit
Transit response is also called natural response
Transit response arises due to presence of C and L in the circuit
Transit is due to R, L, C in the circuit

4, 3, 2 , 1
5, 4, 3, 2
5, 4, 3, 1
5, 1, 4

⇒ The skip distance is the maximum distance upto which ionospheric reflection is possible.
TRUE
FALSE

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ Which mode is called dominant mode in rectangular wave guide?
TE₀₁
TE₁₁
TE₁₀
TE₂₀