Question is ⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is, Options are ⇒ (A) 1.1 kHz, (B) 2.5 kHz, (C) 3.3 kHz, (D) 6.5 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is, Options are ⇒ (A) 1.1 kHz, (B) 2.5 kHz, (C) 3.3 kHz, (D) 6.5 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
A.	1.1 kHz [Wrong Answer]
B.	2.5 kHz [Wrong Answer]
C.	3.3 kHz [Wrong Answer]
D.	6.5 kHz [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected.Ignoring shadows, the port addresses
80 H
85 H
82 H, 83 H
80 H to 85 H

⇒ In the amplifier circuit of figure h_fe = 100 and h_ie = 1000 Ω. The voltage gain of amplifier is a
0.33
0.5
0.66
1

⇒ Which one is a causal system?
y(n) = 3x[n] - 2x[n - 1]
y(n) = 3x[n] + 2x[n + 1]
y(n) = 3x[n + 1] + 2x[n - 1]
y(n) = 3x[n + 1] 2x[n - 1] + x[n]

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor

⇒ An n channel depletion type MOSFET has
lightly doped p substrate and highly doped n source and drain
highly doped p substrate and highly doped n source and drain
highly doped p substrate and lightly doped n source and drain
lightly doped n substrate and highly doped n source and drain

⇒ The dynamic equalising circuit consists of a series combination of capacitor C and resistor R_C across each thyristor. This resistance R_C (along with parallel connected diode)
limits charging current
limits discharging current
limits both charging and discharging currents
none of the above

⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt²
volt/sec
volt-sec

⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top

⇒ The number of valence electrons in a silicon atom is
4
2
1
0

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ Which of the following is correct?
y₂₂ = z₂₂/|z|
y₁₁ = z₂₂/|z|
z₁₁ = y₁₁/|y|
z₂₂ = y₂₂/|y|

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In AM the amplitude of carrier components ... while in FM it
remains constant, does not remain constant
does not remain constant ... remains constant
remains constant... also remains constant
does not remain constant, also does not remain constant

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in bandwidth
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope overload error
C.	Finer quantization of signal	3.	Nyquist rate
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1
A-4, B-2, C-1, D-3

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
35 W
60 W
85 W
100 W

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ The parameter h₁₁ for CB circuit is higher than that for CE circuit.
TRUE
FALSE

⇒ The turn off time of a bipolar transistor is about
0.5 ns
10 ns
70 ns
150 ns

⇒

Assertion (A): The time response, usually, is slower with lag compensation.

Reason (R): The natural undamped frequency and bandwidth are increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A control system is as shown in given figure The maximum value of gain K for which the system is stable
more than 5
equal to 5
less than 1
less than 5

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ Which of the following element has four valence electrons?
Silicon
Germanium
Both (a) and (b) above
None of the above

⇒ A meter coil has a resistance of 100 Ω and a full scale deflection current of 10 mA. To convert it into a voltmeter of 0-200 V range, the series resistance should be
20 kΩ
19.9 kΩ
1.9 kΩ
20.1 kΩ

⇒ The transfer function of a zero-order-hold system is :
(l/s)(l + e^-sT)
(1/s)(1 - e^-sT)
1 - (l/s)e^-sT
1 + (1/s)e^-sT

⇒

Match the following:

	List I (Processor in C)		List II (Output)
A.	Preprocessor	1.	Source code file
B.	Compiler	2.	Executable code in machine language
C.	Linker	3.	Relocatable object code

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2