Question is ⇒ In a JFET, Options are ⇒ (A) the source gate junction is forward biased and gate drain junction is reverse biased, (B) both the junctions are forward biased, (C) both the junctions are reverse biased, (D) the source gate junction is reverse biased and gate drain junction is forward biased, (E) , Leave your comments or Download question paper.

Question is ⇒ In a JFET, Options are ⇒ (A) the source gate junction is forward biased and gate drain junction is reverse biased, (B) both the junctions are forward biased, (C) both the junctions are reverse biased, (D) the source gate junction is reverse biased and gate drain junction is forward biased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a JFET
A.	the source gate junction is forward biased and gate drain junction is reverse biased [Wrong Answer]
B.	both the junctions are forward biased [Wrong Answer]
C.	both the junctions are reverse biased [Correct Answer]
D.	the source gate junction is reverse biased and gate drain junction is forward biased [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ The power input and output in a device are 3650 W and 3385 W with each reading in doubt by ± 10 W. The percentage uncertainty in losses is
± 7.55%
± 3.77%
± 11.32%
± 15.09%

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ Laplace transform of a unit doublet U_-2 (t) is
1/s
s
0
1

⇒ DC voltage of the order of a few mV can be accurately of measured by
PMMC voltmeters
moving iron voltmeter
null balancing potentiometer
electrostatic voltmeter

⇒

Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Method of images is applicable to which fields?
Electrostatic fields only
Electrodynamic fields only
Neither electrostatic fields nor electro-dynamic fields
Both electrostatic fields and electro-dynamic fields

⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
zero
24.14A
10A
14.14A

⇒ Which of the following 8 bit microprocessors has maximum addressing modes?
8085
Z 80
6800
6809

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ In an R-L circuit, the impedance is 30 Ω at a frequency of 100 Hz. At 200 Hz, the impedance should be
30 Ω or more
60 Ω or more
15 Ω or less
more than 30 Ω but less than 60 Ω

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ In a JK flip-flop, J is connected to Q and K is connected to Q outputs. The JK FF converts into a
RS FF
D FF
T FF
Clocked RS FF

⇒ When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is
short circuited
all right
faulty
open circuited

⇒ A 1 ms pulse can be stretched to 1 sec pulse by using
an astable multivibrator
a monostable multivibrator
a bistable multivibrator
a Schmitt trigger circuit

⇒ The inverse response of a system h(n) = aⁿ∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1

⇒ In an n channel MOSFET, the substrate is connected
to negative terminal of battery
to positive terminal of battery
to either positive or negative terminal of battery
none of the above

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ Calculate the electrostatic force of repulsion between two mica particles at a distance of 10^-13 m from each other. Charge on a particle is 3.2 x 10^-19 C. (relative permittivity for mica is 5)
1.843 x 10^-15 N
9.2 x 10^-2 N
14.41 x 10^-9 N
none of these

⇒ Which one of the following parameters does not exist for the two port network shown in the given fig
ABCD
y
h
z

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then array length will be
10 λ
100 λ
20 λ
5 λ

⇒ Induction wattmeter can be used in
ac circuit only
dc circuit only
both ac and dc circuit
ac 3 phase only

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ The normalised form of 1.81 x 10^-11 is
18.1 x 10^-12
18.1 x 10^-13
0.181 x 10^-10
0.0181 x 10^-9

⇒ For the wave shown in figure, the average valu
7.07 A
0.208333333333333
2.5 A
0.5 A

⇒ The properties of FETs resemble closely to
UJT
current transformer
thyristor
thermionic valves

⇒ As compared to a p-n junction diode
a schottky diode has lower cut in voltage and lower reverse saturation current
a schottky diode has higher cut in voltage and higher reverse saturation current
a Schottky diode has lower cut in voltage and higher reverse saturation current
a schottky diode has higher cut in voltage and lower reverse saturation current