Question is ⇒ A Schottky diode clamp is used along with switching BJT for, Options are ⇒ (A) reducing the power dissipation, (B) reducing the switching time, (C) increasing the value of β, (D) reducing the base current, (E) , Leave your comments or Download question paper.

Question is ⇒ A Schottky diode clamp is used along with switching BJT for, Options are ⇒ (A) reducing the power dissipation, (B) reducing the switching time, (C) increasing the value of β, (D) reducing the base current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Schottky diode clamp is used along with switching BJT for
A.	reducing the power dissipation [Wrong Answer]
B.	reducing the switching time [Correct Answer]
C.	increasing the value of β [Wrong Answer]
D.	reducing the base current [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is V_m sin ωt. The peak inverse voltage is
2 V_m
V_m
0.5 V_m
0.25 V_m

⇒ A super heterodyne receiver has an input circuit tuned to a 570 KHz signal. If the intermediate frequency of the amplifier is tuned to 455 KHz. The quality factor Q for a Image Rejection ratio of 125?
100
56.81
42.74
87

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒ When subjected to alternating stresses, an insulating material is characterised by complex dielectric constant ∈^'_r - j∈^"_r . In such materials, the dielectric losses under alternating stress is proportional
∈^"_r
both ∈^'_r and ∈^"_r
∈^'_r
(∈^"_r)²

⇒ The Fourier series representation of a periodic current (2 + 62 cos ωt +48 sin 2ωt) A. The effective value is
(2 + 6 + 24) A
0.333333333333333
0.25
0.0833333333333333

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒

Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ Terra-watt is equal to
10³ W
10⁶ W
10⁹ W
10¹² W

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒ AE 139 is a
tunnel diode
germanium power transistor
photoconductive cell
silicon diode

⇒ Natural commutation can be used in :
DC circuits only
AC circuits only
both AC and DC circuits
none of the above

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I (Types of transmission structure)		List II (Modes of propagation)
A.	Strip line	1.	Quasi TEM
B.	Hollow rectangular waveguide	2.	Pure TEM
C.	Microstrip	3.	TE/TM
D.	Corrugated waveguide	4.	Hybrid

A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4
A-4, B-3, C-1, D-2

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ In figure, the tree branches are bdf. The fundamental loops inc
abc, def, bdea
cea, bdea, abc
cdb, def, bfa
abde, def, cdb

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ The circuit shown in the figure conv
BCD to Binary code
Binary to excess - 3 code
Excess - 3 to Gray
Gray to Binary

⇒ Which camera tube has highest dark current?
Plumbicon
Vidicon
Saticon
GCD imager

⇒ With reference to C programming language, which of the following statements are correct?

An identifier may start with an underscore.
An identifier may end with an underscore.
If is a valid identifier.
The number of significant characters in and identifier is implementation dependent.

Select the correct answer from the codes given below:
1 and 2 only
2 and 3 only
1, 2, 3 and 4
3 and 4 only

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X-plate input is 2 sin ωt, the Y-plate input is
2 sin ωt
2 sin (ωt + 45°)
2 sin (ωt - 45°)
22 sin ωt + 45°)

⇒

Assertion (A): In a parallel in-serial out shift register data is loaded one bit-at a time

Reason (R): A serial in-serial out shift register can be used to introduce a time delay.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ V_th = 0, if
there is no independent source in circuit
there is no dependent source in circuit
voltage source of infinite magnitude
none

⇒ Which of the following is true?
SOP is a two level logic
POS is a two level logic
Both SOP and POS are two level logic
Hybrid function is two level logic

⇒ The region between a pin of parallel perfectly conducting planes of infinite extent is y and z directions is partially filled with a dielectric as shown be
-2
2
0
1

⇒ In 8086 the word address is
the address of the least significant byte
the address of most significant byte
either (a) or (b) depending on the word
neither (a) nor (b)