Question is ⇒ The ratio of diffusion constant for hole DP to the mobility for holes is proportional to, Options are ⇒ (A) T2, (B) T, (C) 1/T, (D) T3, (E) , Leave your comments or Download question paper.

Question is ⇒ The ratio of diffusion constant for hole DP to the mobility for holes is proportional to, Options are ⇒ (A) T2, (B) T, (C) 1/T, (D) T3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
A.	T² [Wrong Answer]
B.	T [Correct Answer]
C.	1/T [Wrong Answer]
D.	T³ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒ Refraction of electromagnetic waves occurs when they
pass through a small slot in a conducting plane
pass into a medium of different dielectric constant
are polarized at right angles to the direction of propagation
encounter a perfectly conduction surface

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ Find I in 4 Ω resis
0.0416666666666667
0.5 A
0.75 A
0.95 A

⇒ In a parallel inverter
each thyristor is turned on twice during each cycle
each thyristor is turned on once during each cycle
each thyristor is turned on either once or twice in each load cycle
each thyristor may be turned on upto four times in each load cycle

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒ Fourier series is applicable for
periodic
finite duration
non periodic
a and b

⇒

Match the following:

	List I		List II
A.	Output of signal generator	1.	Modulated
B.	Error signal from a synchro	2.	Digital
C.	Output of a JK flip flop	3.	Analog
D.	Signal received by radar	4.	Stoichastic

A-1, B-3, C-2, D-4
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2
A-1, B-3, C-4, D-2

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ Which stage generates RF carri
Amplifier
Oscillator
Power supply
All of the above

⇒ The virtual height of an ionospheric layer is __________ true height
equal to
less than
higher than
no relation

⇒

Assertion (A): In a circuit using FET, gate is approximately at dc ground

Reason (R): Self bias stabilizes the quiescent operating point against changes in JFET parameters

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ When temperature is above ferromagnetic Curie temperature, a ferromagnetic material
becomes a paramagnetic material
becomes a very strong ferromagnetic material
becomes diamagnetic material
none of the above

⇒ For a second order system the damping factor is varied from 0 to 1. The locus of poles is
a straight line on imaginary axis
a straight line on real axis
a semi circle
a circle

⇒ In a NAND SR latch S = 0, R = 1 then
Q = 0
Q = 1, Q = 0
it is race condition
none of the above

⇒

Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The 2's complement representation of the decimal number -4 is
100
1100
1011
1010

⇒ In E plane metal plate lens antenna
travelling wavefronts are retarded
travelling wavefront are accelerated
travelling wavefront remains unaffected
none of the above

⇒ Schrodinger wave equation is a
linear equation
differential equation
partial differential equation
none of the above

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of
minority carriers in source
majority carriers in source
charge on gate electrode
minority carriers in drain

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ Higher value of ripple factor indicates
poor rectification
ideal rectification
r.m.s. value to peak value
none of the above

⇒ An n channel depletion type MOSFET has
lightly doped p substrate and highly doped n source and drain
highly doped p substrate and highly doped n source and drain
highly doped p substrate and lightly doped n source and drain
lightly doped n substrate and highly doped n source and drain