Question is ⇒ If f(t) = - f(- t) and f(t) satisfies Dirichlet conditions, then f(t) can be expanded in Fourier series having, Options are ⇒ (A) sine terms only, (B) cosine terms only, (C) cosine and constant terms, (D) sine and constant term, (E) , Leave your comments or Download question paper.

Question is ⇒ If f(t) = - f(- t) and f(t) satisfies Dirichlet conditions, then f(t) can be expanded in Fourier series having, Options are ⇒ (A) sine terms only, (B) cosine terms only, (C) cosine and constant terms, (D) sine and constant term, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If f(t) = - f(- t) and f(t) satisfies Dirichlet conditions, then f(t) can be expanded in Fourier series having
A.	sine terms only [Correct Answer]
B.	cosine terms only [Wrong Answer]
C.	cosine and constant terms [Wrong Answer]
D.	sine and constant term [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ The impulse response h(t) of a linear time-invariant continuous time system is described by h(t) = exp (at) u(t) + exp (βt) u (- t), where u(t) denotes the unit step function, and a and β are constants. This system is stable if
a is positive and β is positive
a is negative and β is negative
a is positive and β is negative
a is negative and β is positive

⇒ An excitation is applied to a system at t = T, and its response is zero for -∞ < t < T, such a system is
non-causal system
Stable system
causal system
unstable system

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒

Assertion (A): A multiplexer can be used for data routing.

Reason (R): A multiplexer has one input and many outputs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following expressions which indicate the step or impulse response of an initially relaxed system

[5 - 4 e^-2t] u(t)
[e^-2t + 5] u(t)
d(t) + 8 e^-2t u(t)
d(t) + 4 e^-2t u(t)

Those which correspond to the step and impulse response of the same system include
1 and 3
1 and 4
2 and 4
2 and 3

⇒ A load commutated chopper circuit has
one thyristor
two thyristors
four thyristors
six thyristors

⇒ The initial state of MOD-16 down counter is 011. After 37 clock pulses, the state of the counter will be
1011
110
101
1

⇒ The reading of the voltmeter in figure will be __________ v
100
150
zero
200

⇒ The number of bits in a nibble is
8
4
2
16

⇒ In a half bridge inverter, the freewheeling diodes are needed
even when load is resistive
only when load is inductive
only when load is inductive or capacitive
for all types of loads

⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease

⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ The absorption of EM wave by the atmosphere depends on
polarization of waves
frequency in use
dist. from T_y
height of antenna

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B

⇒ A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.
A.C., low frequency
A.C., high frequency
D.C., low frequency
D.C. high frequency

⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be
± 0.7%
± 0.9%
± 1.2%
± 0.3%

⇒ Photoelectric emitters in photo tubes are generally made of
alkali metals
metals
semiconductors
metal and semiconductors

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto
from 0 to 1
from about 0.3 to 0.7
from 1 to 5
from 0 to 3

⇒ In the circuit of figure, the value of r_e is (neglecting v_{be100 Ω
75 Ω
50 Ω
25 Ω}

⇒ When a trivalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒

Match the following:

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)