Question is ⇒ Two sinusoidal voltage sources v1 = 50 sin (100t) and v1 = 50 sin (100t + p) are connected in parallel and fed an inductance XL = 2Ω. The cuirent through XL is, Options are ⇒ (A) 25 A, (B) about 17.5 A, (C) zero, (D) 50 A, (E) , Leave your comments or Download question paper.

Question is ⇒ Two sinusoidal voltage sources v1 = 50 sin (100t) and v1 = 50 sin (100t + p) are connected in parallel and fed an inductance XL = 2Ω. The cuirent through XL is, Options are ⇒ (A) 25 A, (B) about 17.5 A, (C) zero, (D) 50 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two sinusoidal voltage sources v₁ = 50 sin (100t) and v₁ = 50 sin (100t + p) are connected in parallel and fed an inductance X_L = 2Ω. The cuirent through X_L is
A.	25 A [Wrong Answer]
B.	about 17.5 A [Wrong Answer]
C.	zero [Correct Answer]
D.	50 A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒

Assertion (A): In an op-amp the gain bandwidth product equals f_finity

Reason (R): The change in open loop gain of an amplifier has almost no effect on closed loop gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Frequency modulation consists in
varying the frequency and amplitude of the carrier in accordance with the instantaneous value of modulating signal
varying the amplitude of the carrier in accordance with the instantaneous value of the modulating voltage
varying the frequency of the carrier voltage in accordance with the instantaneous value of the modulating voltage
vary the frequency of the carrier voltage

⇒ If the load current is high, the pressure coil of wattmeter should be connected directly across the load.
TRUE
FALSE

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ In degenerate p type semiconductor material, the Fermi level,
is in the valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near conduction band

⇒ The power density spectrum of noise voltage of resistor R can be expressed as
2 kTR
1 kTR
0.5 kTR
0.25 kTR

⇒ In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is
TM₁₂
TE₁₃
TE₂₁
TM₂₅

⇒ Which of the following theorems enables a number of voltage (or current) sources to be combined directly into a single voltage (or current) source?
Superposition theorem
Compensation theorem
Millman's theorem
Thevenin's theorem

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
40 V
25.5 V
20 V
2.55 V

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ A voltage wave v = 10 + 20 sin ωt + 7.5 sin 3 ω(t) is applied to a series combination of two elements. The current is i = 5 sin (ωt + 20°) + 1.5 sin (3ωt + 10°). The elements are
R and C
R and L
L and C
both inductances

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ The drain characteristics of JFET in operating region, are
inclined upwards
almost flat
inclined downwards
inclined upwards or downwards

⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)

⇒ Electrostatic voltmeter is suitable only for low voltages.
TRUE
FALSE

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4

⇒

Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.

Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ Beam width of an antenna is expressed in
metres
degrees
ratio of two powers
ratio of two angles

⇒

Assertion (A): A decrease in temperature increases the reverse saturation current in a p-n diode.

Reason (R): When a diode is reverse biased surface leakage current flows.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒ Holes and electrons move in opposite directions.
TRUE
FALSE

⇒ The circuit given bel
Circuit is band stop with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is band pass with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is oscillator, oscillation at two frequencies 39.7875 Hz to 1592 Hz depending on R₃, R₄, R₅ and R₆
None of these