Question is ⇒ A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere., Options are ⇒ (A) equal and of same again, (B) equal and of opposite sign, (C) unequal and of same sign, (D) unequal and of opposite sign, (E) , Leave your comments or Download question paper.

Question is ⇒ A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere., Options are ⇒ (A) equal and of same again, (B) equal and of opposite sign, (C) unequal and of same sign, (D) unequal and of opposite sign, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere.
A.	equal and of same again [Wrong Answer]
B.	equal and of opposite sign [Correct Answer]
C.	unequal and of same sign [Wrong Answer]
D.	unequal and of opposite sign [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In controlled heating circuits, thyristors act as
rectifier
inverter
ac regulator
chopper

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ In a piezoelectric crystal, application of a mechanical stress would produce
plastic deformation of the crystal
magnetic Dipoles in the crystal
electric polarization in the crystal
shift in the Fermi level

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ j⁶ =
j
j²
j³
- j

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ Which of the following terms are applicable to troposcatter propagation?
Faradays rotation
SIOs
Fading
Atmospheric storms

⇒ Assuming that flip-flops are in reset condition initially, the count sequence observed at Q_A in the circuit show
0010111...
0001011...
0101111...
0110100...

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ Magnetic amplifier is used for
voltage amplification
power amplification
current amplification
frequency amplification

⇒ If sound wave has an intensity of 10 Pa. The dB level is about
1.139 dB
11.39 dB
113.9 dB
1139 dB

⇒ UJT can be used for
firing an SCR
turning off an SCR
both firing and turning off an SCR
none of the above

⇒ A radio frequency signal contains the following three frequencie
Push pull amplifier
Wideband amplifier
Audio frequency amplifier
Tuned voltage amplifier

⇒

Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases.

Reason (R): Capacitance of any layer is inversely proportional to thickness.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ The heat sink disposes off heat mainly by
radiation
natural convection
forced convection
conduction

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be
32 μ sec
20 μ sec
21 μ sec
22 μ sec

⇒ In a microprocessor
all instructions need only one machine cycle
some instructions need only one machine cycle while some other instructions need more than one machine cycle
all instructions need only fraction of one machine cycle
some instructions need less than one machine cycle

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): Most PCs use static RAM for main memory.

Reason (R): Static RAM is faster than dynamic RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒ For edge triggering in flip flops, manufacturers use
RC circuit
direct coupled design
either RC circuit or direct coupled design
none of the above

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ In 8085 microprocessor, how many lines are there in address bus?
6
8
12
16

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒ Pick out the odd one
stochastic variable
stochastic function
random variable
random experiment