Question is ⇒ Digital technologies being used now-a-days are, Options are ⇒ (A) DTL and EMOS, (B) TTL, ECL, CMOS and RTL, (C) TTL, ECL and CMOS, (D) TTL, ECL. CMOS and DTL, (E) , Leave your comments or Download question paper.

Question is ⇒ Digital technologies being used now-a-days are, Options are ⇒ (A) DTL and EMOS, (B) TTL, ECL, CMOS and RTL, (C) TTL, ECL and CMOS, (D) TTL, ECL. CMOS and DTL, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Digital technologies being used now-a-days are
A.	DTL and EMOS [Wrong Answer]
B.	TTL, ECL, CMOS and RTL [Correct Answer]
C.	TTL, ECL and CMOS [Wrong Answer]
D.	TTL, ECL. CMOS and DTL [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The following sequence represents autocorrelation of a real valued signal. The energy of real valued sequence is given by __________ x(n) = {1, _, 3, _, 5, _, 7, _, 9, 10, _, 8, _, 6, _, 4, _, 2
2[1² + 2² + 3² + 4² + 5² + 6² + 7² + 8² + 9²] + 10²
10
10²
2[1² + 2² + 3² + 4² + 5² + 6² + 7² + 8² + 9² + 10²]

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ The emitter resistor R_E in the emitter of CE amplifier stabilizes the dc operating point against variation in
temperature only
β of transistor
both temperature and β
none of the above

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ If σ is standard deviation, variation is
σ - 1
σ^1.5
σ²
σ³

⇒ Consider the following DO statement in Fortran 77 1
11
10
4

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
21 kHz
22 kHz
42 kHz
44 kHz

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ System satellites orbit the Earth once in
24 hours
12 hours
1 hours
6 hours

⇒ In 8085, the pairing of registers B, C, D, E, H, L is
B - C, D - E, H - L
B - D, C - E, H - L
B - C, D - L, H - E
B - H, D - E, C - L

⇒ The v-i characteristic shown in the given figure is
thermistor
photoconductor
varistor
none of the above

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ The Hall constant in Si bar is given by 5 x 10³ cm³/ coulomb, the hole concentration in the bar is given by
10⁵/cm³
1.25 x 10¹⁵/cm³
1.5 x 10¹⁵/cm³
1.6 x 10¹⁵/cm³

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒

Assertion (A): Light triggering is very suitable for HVDC transmission.

Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The depletion layer around p-n junction in JFET consists of
hole
electron
immobile charges
none of the above

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ Consider the following statements about diamagnetic material and diamagnetism.

The materials have negative magnetic susceptibility.
At very low temperature diamagnetic materials.

Which of the statements given above is/are correct?
1 only
2 only
Both 1 and 2
neither 1 nor 2

⇒ The accuracy of a multimeter is about
± 0.5%
± 3%
± 0.01%
± 10%

⇒ The sensitivity of a potentiometer can be increased by
increasing the length of wire
decreasing the length of wire
increasing the current in the wire
decreasing the current in the wire

⇒ Waveguides are generally used above
20 MHz
100 MHz
200 MHz
1000 MHz

⇒ Consider the following stateme
2 and 4
1 and 2
1 only
3 and 4

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ What are the values of E_max and E_min displayed on the oscilloscope, when a 1 kV P-P carries is modulated to 50%?
2 kV, 0.5 kV
1 kV, 0.5 kV
0.75 kV, 0.25 kV
0.5 kV, 1.5 kV

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2