Question is ⇒ If for a silicon n-p-n transistor, the base to emitter voltage (VBE) is 0.7 V and the collector to base voltage VCB is 0.2 Volt, then the transistor is operating in the, Options are ⇒ (A) normal active mode, (B) saturation mode, (C) inverse active mode, (D) cut off mode, (E) , Leave your comments or Download question paper.

Question is ⇒ If for a silicon n-p-n transistor, the base to emitter voltage (VBE) is 0.7 V and the collector to base voltage VCB is 0.2 Volt, then the transistor is operating in the, Options are ⇒ (A) normal active mode, (B) saturation mode, (C) inverse active mode, (D) cut off mode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If for a silicon n-p-n transistor, the base to emitter voltage (V_BE) is 0.7 V and the collector to base voltage V_CB is 0.2 Volt, then the transistor is operating in the
A.	normal active mode [Correct Answer]
B.	saturation mode [Wrong Answer]
C.	inverse active mode [Wrong Answer]
D.	cut off mode [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the answer using the following codes :
1, 2 and 3
1, 2, 4, and 6
3, 4, 5 and 6
2, 4 and 5

⇒ The circuit in figur
positive clamper
negative clamper
positive peak clipper
negative peak clipper

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ A ripple counter has 4 bits and uses flip flops with propagation delay time of 25 ns. The maximum possible time for change of state will be
25 ns
50 ns
75 ns
100 ns

⇒ In figure, V₁ = 40 V when R = 10 Ω, if R = 0, V₂ wil
40 V
30 V
20 V
10 V

⇒ Consider the following circuits. Assume all gates to have finite propagation d
(1) only
(1) and (2) only
(2) (3) and (4) only
All (1) (2) (3) and (4)

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ Kirchoff's laws are applicable to
dc circuits
circuits with sinusoidal excitation only
dc circuits and circuits with sinusoidal excitation
circuits with any excitation

⇒ The pointer of an indicating instrument should be
very light
very heavy
neither heavy nor light
heavy

⇒ The storage capacity of a CD is
360 k bytes per side
360 M bytes per side
540 k bytes per side
540 M bytes per side

⇒ A typical error rate on satellite circuits is one bit error in
10⁷
10³
10²
10¹⁰

⇒ The amplifier used in miller voltage sweep should have a gain of
-∞
1
+∞
-1

⇒ Which of the following best represents the bandwidth of an actual op-amp?
100 Hz to 1 MHz
0 Hz to 100 kHz
0 Hz to 10 MHz
0 Hz to infinity

⇒

Assertion (A): In root locus the breakaway and break in points either lie on real axis or occur in complex conjugate pairs.

Reason (R): All root locus asymptotes intersect on real axis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ At the peak of negative half cycle in fi
diode A is forward biased and diode B is reverse biased
both diodes are reverse biased
both diodes are forward biased
diode A is reverse biased and diode B is forward biased

⇒ Magnetic recording tape is most commonly made from
small particles of iron
silicon iron
ferric-oxide
silver nitrate

⇒ The current through R₁ is(If β = 99, V_BE = 0.7
0.1 mA
0.35 mA
0.2 mA
none

⇒ In figure, the current
0.0416666666666667
0.0833333333333333
0.166666666666667
0.333333333333333

⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ For type 0 system the starting point (i.e. ω = 0) of polar plot is finite and is on positive real axis.
TRUE
FALSE

⇒ Two impedances 10 - j 10 and 10 + j 10 are connected in parallel. Their combined impedance is
5 + j5
5 - j5
10 + j0
20 - j10

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ For the infix expression (A/B) * (C * F + (A - D) * E) the corresponding Post fix notation is
A / D * CF AD - F * +
AB / CF * AD - E * + *
AB / C * FAD - E * + *
None of the above

⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers
WESTAT
INSAT-IC
ARABSAT
INSAT-ID