Question is ⇒ The circuit shown in the figure is tha, Options are ⇒ (A) non-inverting amplifier, (B) Inverting amplifier, (C) an oscillator, (D) Schmitt trigger, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit shown in the figure is tha, Options are ⇒ (A) non-inverting amplifier, (B) Inverting amplifier, (C) an oscillator, (D) Schmitt trigger, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit shown in the figure is tha
A.	non-inverting amplifier [Wrong Answer]
B.	Inverting amplifier [Wrong Answer]
C.	an oscillator [Wrong Answer]
D.	Schmitt trigger [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Foster Seeley discriminator uses a
single tuned circuit
double tuned circuit with primary and secondary tuned to the same frequency
double tuned circuit with primary and secondary tuned to the different frequency
none of the above

⇒ Which one of the following statements regarding compandor is FALSE?
It compresses the higher-amplitude parts of a signal before modulation and expands them back to normal again after demodulation.
It gives preferential treatment to the weaker parts of the signal
For weaker signals it gives a poor ratio of signal strength to quantizing error
Weaker signals, traverse more quantum steps than they would do otherwise and so quantizing error is reduced.

⇒ A transistor has two p-n junctions. The batteries should be connected such that
both junctions are forward biased
both junctions are reverse biased
one junction is forward biased and the other is reverse biased
either (a) or (b)

⇒ The Shannon-Hartley law
refers to noise
defines bandwidth
describes signalling rate
refers to distortion

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-4, B-2, C-3, D-1
A-2, B-4, C-3, D-1

⇒ The communicating capacitor reduces turn on time because
it acts as an open circuit
it allows maximum base circuit to flow
it aids in removing the excess carrier from the base region
none of these

⇒ A clock signal driving a 6-bit ring counter has a frequency of 1 MHz. How long is each timing bit high?
1 ms
2 ms
3 ms
6 ms

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒

Match the following:

	List I (Location of characteristics roots)		List II (System characteristic)
A.	(- 1 + j), (- 1 - j)	1.	Marginally stable
B.	(- 2 + j), (- 2 - j), (2, j) (- 2, j)	2.	Unstable
C.	- j, j - 1, 1	3.	Stable

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ If A is 1011, A" is
1011
100
1100
1010

⇒ The distance between target and radar is reduced to half. Power received increases by
42751
42739
4 times
16 times

⇒ It is required that a strain gauge has gauge factor of 100. The proper strain gauge is
constantan strain gauge
nichrome strain gauge
semiconductor strain gauge
alloy strain gauge

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ India's Polar Satellite Launch vehicle (PSLV) to be ready in 1991 is designed to launch 1000 kg spacecraft into __________ orbit.
geostationary
equatorial
polar
sun-synchronous polar

⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
a, b, d
a, b, c
all
a, b, g, c, d

⇒

Assertion (A): A Smith chart can be used for a number of calculations of a transmission line

Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ Sulphur hexafluoride is used in
transformers
generators
relays
circuit breakers

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W

⇒ Henry is equivalent to
Volts/Ampere
Weber/Volt
Weber/Ampere
Weber/Ampere²

⇒ Mechanical impedance is the ratio of
rms force to rms velocity
rms force to rms displacement
rms velocity to rms displacement
none of the above

⇒ Directivity means
maximum directive gain
zero directive gain
minimum directive gain
none of the above

⇒ A five bit binary adder is used to add 01001 and 00111. The adders from LSB position are numbered as FA₀, FA₁, FA₂ and FA₃. The outputs of FA₂ are
SUM = 0
SUM = 0, CARRY = 1
SUM = 1, CARRY = 0
SUM = 1, CARRY = 1

⇒ One ampere means the flow of
One coulomb each minute
One electron per second
One coulomb per second
One coulomb each hour

⇒ What are the contents of the accumulator after the RIC has been executed?
40 H
41 H
42 H
43 D

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ In its lowest state, the electron is bound to the field of proton by an energy equal to
100.5 eV
51.2 eV
13.6 eV
0.2 eV